User manual LG AF999NI

[. . . ] ü Messenger Function The projector can display the text data transferred via the network on the screen. This manual is only intended to explain Network function only. For safety, operations or any other issues, refer to the Safety Guide and User's Manual (concise and detailed). WARNING Before using this product, be sure to read all manuals for this product. [. . . ] Set the same time difference as the one set on your computer. Click the [ON] check box to retrieve Date and Time information from the SNTP server and set the following items. Configures the SNTP server address in IP format. · The address allows not only IP address but also domain SNTP Server Address name if the valid DNS server is setup in the Network Settings. The maximum length of host or domain name is up to 255 characters. Cycle Configures the interval at which to retrieve Date and Time information from the SNTP server (hour:minute). Click [Apply] button to save the settings. NOTE · The new configuration settings are activated after restarting the network connection. When the configuration settings are changed, you must restart the network connection. You can restart the network connection by clicking [Network Restart] on the main menu. · If you connect the projector to an existing network, consult a network administrator before setting server addresses. · To enable the SNTP function, the time difference must be set. · The projector will retrieve Date and Time information from the time server and override time settings when SNTP is enabled. Refer to the table below for details. NOTE · The setting value may not match with the actual value if the user changes the value manually. In that case, please refresh the page by clicking [Refresh] button. Controls the projector. Item Main Power Input Source Picture Mode Blank On/Off Mute Freeze Magnify Template My Image My Image Delete Picture Brightness Contrast Gamma Color Temp Color Tint Sharpness Active Iris My Memory Save My Memory Recall 28 Description Turns the power on/off. In some input signal sources, it might stop "Magnify" even though it does not reach to maximum setting value. (This item is available only for CP-X2510N or AF999NI. ) Saves the My Memory data. Network Functions 3. 1 Configuring and controlling the projector via a web browser (continued) Item Image Aspect Over Scan V Position H Position H Phase H Size Auto Adjust Execute Input Progressive Video NR Color Space Component S-Video Format C-Video Format Computer in1 Computer in2 Frame Lock Computer in1 Frame Lock Computer in2 Setup Auto Keystone Execute Keystone V Eco Mode Mirror Monitor Out Computer in1 Monitor Out Computer in2 Monitor Out Component Monitor Out S-Video Monitor Out - Video Monitor Out Standby Description Selects the aspect setting. Selects the video noise reduction setting. Selects the COMPUTER IN1 input signal type. Selects the COMPUTER IN2 input signal type. Turns the FRAME LOCK-COMPUTER IN1 function on/off. Turns the FRAME LOCK-COMPUTER IN2 function on/off. [. . . ] Network Functions 3. 8. 2 Communication setup To configure the setup of the communication using NETWORK BRIDGE for the projector, use items in the COMMUNICATION menu. Open the menu of the projector and select the OPTION - SERVICE - COMMUNICATION menu. (OPTION menu - SERVICE ­ COMMUNICATION in the User's Manual Operating Guide) 1) Using the COMMUNICATION TYPE menu, select the NETWORK BRIDGE for the CONTROL port. 2) Using the SERIAL SETTINGS menu, select the proper baud rate and parity for the CONTROL port, according to the specification of the RS-232C port of the connected device. Item BAUD RATE PARITY Data length Start bit Stop bit Condition 4800bps/9600bps/19200bps/38400bps NONE/ODD/EVEN 8 bit (fixed) 1 bit (fixed) 1 bit (fixed) 3) Using the TRANSMISSION METHOD menu, set up the proper method for the CONTROL port according to your use. [. . . ]