User manual LG AHH40LHG1

[. . . ] If the supply cord is damage, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. strongly recommended to be installed with Earth Leakage Circuit Breaker (ELCB) or Residual Current Device (RCD) to prevent electric shock or fire. This equipment must be earthed to prevent electrical shock or fire. In case of emergency or abnormal conditions (burnt smell, etc), turn off the power supply, and please consult authorized dealer. [. . . ] Do not touch the sharp aluminium fin, sharp parts may cause injury. Do not switch ON the indoor when waxing the floor. After waxing, aerate the room properly before operating the unit. Do not install the unit in oily and smoky areas. ensure drainage pipe is connected properly. After long period of use, make sure the installation rack is not deteriorate to prevent the unit falls down. Remove the batteries if the unit is not going to be used for a long period of time. New batteries of the same type must be inserted following the polarity stated to prevent malfunction of the remote control. This model is not suitable for 24 hours nonstopping operation in heating mode below -5°C. When the outdoor temperature is below -5°C and you use this model out of above conditions, the outdoor unit might be frozen up and stop operation for protection control. For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. Press down both ends of the front panel to close it securely. Air filters cleaning is needed every two weeks. Dry the filters thoroughly under the shade, away from fire or direct sunlight. Indoor fan stops occasionally during automatic fan speed setting. Airflow continues even after operation has stopped. This may due to damp smell emitted by the wall, carpet, furniture or clothing. Extraction of remaining heat from the indoor unit (maximum 30 seconds). Operation is delayed a few minutes after restart. Power indicator blinks during HEAT mode with no warm air · Indoor fan stops occasionally during heating operation. Power indicator blinks before the unit is switched on. ⷠThis is a preliminary step in preparation for the operation when the ON timer has been set. [. . . ] These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. For more information about collection and recycling of old products and batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items. [. . . ]