User manual LG AR407FD

[. . . ] The purpose of a dehumidifier is to remove the excess moisture from the air, avoiding the dama- ge caused by condensation. Experts have established that the optimum environmental conditions for our well being and for the home are obtained between 40% and 60% relative humidity. With very low temperatures, you are recommended to heat the room even minimally. This considerably increases the dehumidifying power of the appliance. [. . . ] The manufacturer is not liable for damage deriving from failure to follow these instructions. Keep the list of Service Centres and identify the Centre nearest you. Electrical connections After moving the appliance, wait at least an hour before turning it on again. Before plugging the appliance into the mains socket, check that: · The mains power supply corresponds to the working voltage indicated on the rating plate. · The power socket and electrical circuit are adequate for the appliance. · The power socket matches the plug. If this is not the case, have the plug replaced by a qualified electrician; · The mains socket is adequately earthed. General safeguards · Do not install the appliance in rooms containing gas, oil or sulphur. Do not use the appliance on sloping surfaces. Keep the appliance at least 50 cm away from flammable substances (alcohol etc) or pressurised containers (e. g. Do not rest heavy or hot objects on top of the appliance. Always transport the appliance upright or resting on one side. Remember to drain the condensate tank before moving the appliance. 2 3) Make sure the end of the hose is no higher than the spout or water could remain in the tank. Make sure there are no kinks in the hose (Fig. 4 HOW TO DEHUMIDIFY Display Display DecreasePulsante humidity button decremento umidità Fan button Pulsante Fan Pulsante Increase humidity incremento umidità button Hygrometer/ termometro/igrometro thermometer button Pulsante MODE button ON/Standby button Pulsante ON/Stand by Pulsante MODE Description of buttons ON/Standby" button ON/Standby" button "MODE" button Selects the operating modes: dehumidifying, dry, smart and fan "Fan" button Selects fan speed Hygrometer/thermometer button Temporarily displays the temperature and humidity measured in the room by the appliance. N. B. : the measurements displayed are indicative only. Humidity increase/decrease buttons Adjusts the percentage of humidity present in the room, increasing it or reducing it by steps of 5%. Display Meaning of the codes or symbols which may be displayed: -- Indicates that the appliance is in standby mode. Indicates that the tank is full, absent or positioned incorrectly. Indicates that the appliance is operating at low temperatures. In this situation, ventilation cycles are alternated with dehumidification cycles to avoid the formation of ice. For use in particularly cold environments, you are recommended to heat the room to raise the ambient temperature even minimally. This allows the dehumidifier to operate in conditions that improve its performance and accelerate the dehumidifying process. Indicates that there may be a fault with the probes, or that the humidity in the room is too low to be measured. 14 MODE SELECTION 1) Plug the appliance into a mains socket. [. . . ] When the appliance reaches the set level of humidity it will stop and the fan will come on at regular intervals to maintain a correct relative humidity reading. As soon as the humidity increases above the set point, the appliance will automatically resume dehumidification operation. Dry mode In Dry mode, the appliance operates constantly at maximum power. This mode is useful to dehumidify the room rapidly. Press the MODE button and choose Dry mode ( symbol on). [. . . ]