User manual LG BH6730S

[. . . ] * Install the product only on a vertical wall. The manufacturer is not responsible for issue from installing the product on severely wall or on the ceiling. * Keep the included accessories out of reach of babies or children as it can cause safety issues including suffocation from swallowing the parts. * Make sure screws are tight against the wall, but do not overtighten. [. . . ] * Be careful with the tools used during installation to prevent accidents or damage. 3 ENGLISH Installation method - Tools you will need : Phillips head "+" driver(Manual or motorized) Ø4mm drill bit for wood or steel / Level / Stud finder / Drill. You may also need an 8mm socket wrench or an 8mm drill bit for concrete. - Installation method is described based on the LSW200B model. The actual product may differ from the picture. 1 Fixating the mounting bracket on the TV If the screw will not fully tighten when using a guide spacer, recheck the assembly depth of the screw and  refer to the technical service manual. <Work procedure> Guide spacer 1. Check to see if the display has screws installed into the mounting holes. Assemble the guide spacer and the guide spacer screw in order as shown in the picture. - Assemble the guide spacer to the set by tightening the Install the PVC washer on models screw. 37/42/47LE53*, 37/42/47LE55*, - Tighten the screw until the set, guide spacer and the screw 42/47/55LX65*, 42/47/55LX68* are fully pressing against one another. Install the wall mount only after - Use the "+" driver (Manual or motorized) when tightening attaching the PVC washer the screw. Guide spacer screw 2 How to attach to masonry walls - Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry brick and hallow block that do not crack. Please follow the below direction. - Check the material of the wall and the thickness of the finishing. Locate and mark the centers of the wall studs using a stud finder. b. After aligning the wall bracket on the wall where the center of the wood stud is marked, mark the location of the screws and then remove the wall bracket. Use a level to make sure your screw marks are level. Use the 4mm drill bit for wood to drill holes with the depth of 76mm or above where the wall mount screw location is marked on the wall. Tighten the wall mount screws for the wall bracket on the drilled hole. → At this time, tighten the screw so that the wall, wall bracket and the wall mount screw are pressed against one another. (Drywall can be damaged when tightened with excessive force, please be careful. ) → When tightening the screw use the "+" driver (Manual or motorized) or 8mm wrench. 4 How to assemble the wall mount support and display - Always install the display with 2 or more people. Safety clip screw 1.  et the display with the guide spacer assembled on the wall S mount bracket on the wall in arrow direction. At this time, align the bottom assembly part and lift the set up lightly to align the top part. When adjusting the location, assemble the provide safety clip as shown in the picture to prevent the product from moving. [. . . ] Tighten the safety clip screw completely. If the safety clip is not tightened as shown in the picture, the product can fall off. → Pull on the bottom of the set to make sure the display is secure. → When installing a display rotated, only rotate the display 90 degrees (portrait mode). [. . . ]