User manual LG BX-401C

[. . . ] Please read this manual carefully before operating your set. Record model number and serial number of the set. See the label attached on the bottom of the set and quote this information to your dealer when you require service. Model number Serial number : : LG DLP PROJECTOR BX401C OWNER'S MANUAL DLP PROJECTOR Warning This is a class A product. [. . . ] Press the , button to select the desired preset time. 4. The timer starts to operate if you select specific time. G Time alarm function : If you select a specific time, it is displayed in minute units. After 1 minute, the remaining time is displayed at the bottom right of the screen, and then disappears after 5 seconds. When the remaining time is displayed, other OSD windows are closed. When the set time is reached, `0 minute' flickers 10 times at 1 second intervals, and then disappears. G Time keeper function : If you select a specific time, it continues to be displayed in minute(`) and second(") units. Even though other OSD windows appear, the remaining time is displayed again after the windows are closed. 0' 00" flickers 10 times at 1 second intervals, and then disappears. 5. If the set time disappears because of the use of other menus, press the TIMER button on a remote to display the set time again. G G The Time alarm function and the Time keeper function cannot be used at the same time. The Time alarm function can be set from 5 to 60 minutes at 5 minute intervals (Off, 5, 10, 15, 20, . . . . . . . . . . . . . . , 55, 60 minutes). G The Time keeper function can be set from 1 to 10 minutes at 1 minute intervals, and from 10 to 60 minutes al 5 minute intervals (Off, 1, 2, 3, 4, . . . . . . . . . . . . . . , 8, 9, 10, 15, 20, 25, . . . . . . . . . . . . . . , 55, 60 minutes). G You can use this function through the MENU button. G Press the EXIT button to exit the menu screen. 25 Function Using Digital Zoom Function * This function is available only in RGB input mode. The Zoom -/+and Position values return to their defaults when you change the SOURCE or input signal, or turn the power off. Adjusting the Zoom 1. Press the ZOOM button on the remote control. Press the , Adjusting the Position 1. Press the ZOOM button on the remote control. Press the , button to select Zoom -/+ item. button to select Position item. Zoom -/+ Position Reset MENU Exit Move 100 % Zoom -/+ Position Reset MENU Exit 110 % Press OK to Start Select Move OK 3. Press the choice. G , button to adjust Zoom -/+ to your You can adjust Zoom -/+ in 5%increments from 100%to 250%. G You can also use this function by using the MENU button. G Press the EXIT button to exit the menu screen. 3. When the window below appears / / at the bottom right corner of the screen, press the / to adjust the position. When the arrow turns black, maximum adjustment has been reached and no further adjustment can be made. Prev. G Position is activated only when Zoom --/+is set to more than 105%. [. . . ] Keep the Lamp away from heat sources such as radiators, stoves etc. - To reduce the risk of fire do not expose the lamp to liquids or foreign materials. - Do not place the lamp near any heat source. - Make sure the new lamp is securely tightened with screws. [. . . ]