User manual LG C25A24T

[. . . ] READ INSTRUCTIONS All the safety and operating instructions should be read before the unit is operated. RETAIN INSTRUCTIONS The safety and operating instructions should be retained for future reference. HEED WARNINGS All warnings on the unit and in the operating instructions should be adhered to. FOLLOW INSTRUCTIONS All operating and use instructions should be followed. [. . . ] pressing VOL 2 Adjust. the volume level bywill be indicated + or ­ The volume level on the screen by green bars. As the volume level increases, so do the number of bars. If the volume decreases, the number of green bars also decreases. option to 3 Set the TV/CABLE menupage 14). the appropriate position (see - VHF/UHF channels TV CABLE - CABLE TV channels 4 Press the Direct Channel Selection buttons to select the channel. To select analog channels When the TV/CABLE menu option is in the TV position, all channels can be instantly selected by using two buttons. (For example, to select channel 2, press "0", then "2". If you press only "2", channel selection will be delayed for a few seconds. ) For channels 10 and above, press the 2 digits in order. When the TV/CABLE menu option is in the CABLE position, channels can be selected as follows: Press 0 twice, then 1-9 as needed. Example, to select channel 2, press 002. 10-12: Press 0, then remaining 2 digits. Example, to select channel 12, press 012. To confirm the sleep timer setting, press SLEEP and the remaining time will be displayed for a few seconds. To cancel the sleep timer, press SLEEP repeatedly until the display turns to 0. 18 J33A0621B_EN. indb 18 1/31/08 5:31:27 PM Setting the V-Chip An age limitation can be set to restrict children from viewing or hearing violent scenes or pictures that you may choose to exclude. The restriction applies to "TV RATING" and "MOVIE RATING" if this data is transmitted. You may set this restriction separately. To use the V-Chip function, you must register a password. To set a password 1 Press MENU/ENTER. 2 Press or to select menu, then press or "V-CHIP". The password entering screen appears. 4 Select and enter a password (4 digits) using the number buttons (0-9), then press MENU/ENTER. " " appears instead of the number. 5 Enter the same password again to confirm, then press MENU/ENTER. The password is now set and the V-CHIP menu appears on the screen. NOTES: · If you forget the password, contact Customer Service at 1-888-865-3026 for assistance. Your original remote control will be required. · To avoid forgetting the password, write it down and keep it in a safe place. 19 J33A0621B_EN. indb 19 1/31/08 5:31:30 PM ENGLISH Setting the V-Chip To set the V-CHIP (continued) 1 Press MENU/ENTER. 2 Press or to select (OPTION) menu. 3 Press 4 Press or to select "V-CHIP". to display the password entering mode. [. . . ] · Check CABLE connection or VHF/UHF antenna, reposition or rotate antenna. · Set closed caption decoder in the menu. Display is not shown in your · Select proper language in the menu options. language. Digital broadcasting · Check digital signal strength. [. . . ]