User manual LG CP05C10

[. . . ] Close attention is necessary when used by or near children. Do not use the vacuum cleaner if the power cord or plug is damaged or faulty. If the power cord is damaged, it must be replaced by an approved LG Electronics Service Agent to avoid a hazard. Do not handle plug or vacuum cleaner with wet hands. [. . . ] Proper voltage is listed onthe bottom of vacuum cleaner. Keep children away and beware of obstructions when rewinding the cord to prevent personal injury. Turn off all controls before unplugging. Do not use it if it is damaged, cut or punctured. Failure to do so could result in death, or electrical shock. If plug does not fit, contact a qualified electrician to install the proper outlet. Do not use with any opening blocked: keep free of dust, lint, hair, and anything that may reduce air flow. Make sure the filters (exhaust filter and motor safety filter) are completely dry before replacing in the machine. Do not use vacuum cleaner without dust tank and/or filters in place. Do not use vacuum cleaner to pick up sharp hard objects, small toys, pins, paper clips, etc. Do not dry the filter in a clothes dryer. - If you pull the latch (30), the elbow tube can be bent. - If you stretch the elbow tube, it is returned to its position. Using the cleaning head and Accessory Nozzles (depending on model) Fit the large cleaning head onto the end of the tube. â· The 2- position head (7) is equipped with a pedal (8) which allows you to alter its position according to the type of floor to be cleaned. Use the dusting brush & crevice tool to vacuum clean the brush and fan. â· Crevice Tool (9) For vacuuming in those normally inaccessible places i. Dusting brush (10) For vacuuming picture frames, furniture outlines, books and other uneven objects. Pull out the supply cord to the desired length and plug into the socket. How to plug in and use Adjusting the power level Electronic power control (27) MIN: Low power MAX: Full power Park-System (17) For short breaks during vacuuming, for example to move a small piece of furniture or a rug, use the "Park system" to support the flexible hose and cleaning head. The dustbag needs changing when the cleaner is set to maximum power and the cleaner head window (19) is completely coloured red. Even if the dustbag does not appear to be full at this stage. [. . . ] To refit a new bag push the cardboard support of a new bag into the bag mount (22) until it will go to further. If your appliance is fitted with a fabric dust bag (26) follow the instructions as follows: Pull the clip (36) out and empty the fabric dust bag, then set the clip back and push it until it can close the dust bag completely. Note: as the appliance is fitted with a safety device which checks that the bag is in place you cannot close the lid if the bag is not fitted correctly. Cleaning the motor filter The motor filter is situated inside the appliance between the dust bag and the motor. [. . . ]