User manual LG CS771DM

[. . . ] If this equipment does cause harmful interference to radio or television reception (which can be determined by turning the equipment off and on), the user is encouraged to try to correct the interference by using one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and the receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. [. . . ] Connect the 15 pin VGA connector of the supplied signal cable to the output VGA video connector on the PC and the matching input connector on the rear of the monitor. If you cannot attach the cable easily, turn the connector upside down and try again. When mated, tighten the thumbscrews to secure the connection. Locate the appropriate MAC to VGA adapter block at your local computer store. This adapter changes the high density 3 row 15 pin VGA connector to the correct 15 pin 2 row connection to mate with your MAC. Attach the other end of the signal cable to the side of the adapter block with 3 rows. Connect the attached adapter block/signal cable to the video output on your MAC. One end of the AC power cord is connected into the AC power connector on the back of the monitor. The other end is plugged into a properly grounded threeprong AC outlet. If you see the NO SIGNAL message, check the signal cable and connectors. After using the system, power OFF the monitor, then the PC. IBM PC MACINTOSH MIC. A single press of the ENTER button will present you with the Main Menu of the on screen display system with the first ( ) highlighted. The main picture area will also show the select icon ( )and next icon ( ). 1. The OSD system should look like: HORIZONTAL SELECT: POSITION NEXT: 2. To adjust H Position ( The display will look like: HORIZONTAL POSITION MAIN : When you are done, Press the main button ( main menu to make another selection. 3. You want to move the next icon, Adjust the next button ( The display will look like: HORIZONTAL SIZE SELECT: NEXT: U U U OSD ), Press the enter button once. 85% OSD ADJ: )once to return to )control. OSD A9 On Screen Display(OSD) Selection and Adjustment You were introduced to the procedure of selection and adjusting an item using the OSD system. Listed below are the icons, icon names, and icon descriptions of the items that are shown on the Menu. OSD Adjust Horizontal Position HORIZONTAL POSITION Description To move picture image left and right. Moves the screen image right. 85% MAIN : Horizontal Size HORIZONTAL SIZE MAIN : Vertical Position VERTICAL POSITION 85% MAIN : Vertical Size VERTICAL SIZE 85% MAIN : Side Pincushion SIDE PINCUSHION 85% MAIN : Trapezoid TRAPEZOID 85% MAIN : U U U U U U OSD ADJ: 85% OSD To adjust image width. Increases the size of the screen image. ADJ: To move image up and down. Moves the screen image down. OSD ADJ: To adjust image height. Increases the size of the screen image. ADJ: OSD To correct the bowing in and out of the image. [. . . ] 1 HZ OPERATING FREQUENCY HF : 30 - 70 KHZ VF : 50 - 160 HZ POWER MANAGEMENT 20 SEC. *Horizontal Frequency: 30-70kHz *Vertical Frequency: 50-160Hz Use the graphics board's utility software to change the frequency setting (Refer to the manual for graphics board). There is no active signal coming from the PC. The signal cable is not fastened securely. Check the computer power and graphics adapter configuration. [. . . ]