User manual LG DF9901P

[. . . ] Temperature and Humidity Ranges . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Cleaning Your Air Conditioner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Solving Common Problems . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 10 The illustrations in the step-by-step procedures use four different symbols: PRESS PUSH IMPORTANT NOTE E-3 ENGLISH Air Conditioning Unit - Main Parts and Control Panel The design and shape are subject to change according to the model. Air inlet (Outside) Air outlet Air inlet (Inside) Air Filter (The air filter is located in inside) Ventilation lever Inner air flow blades (right/left orientation) Power plug (The type of power plug may differ according to the type of local power supply. ) Temperature control dial Operating mode selection dial E-4 Cooling Your Room ENGLISH You must select the Cool mode if you wish to lower the temperature in your room. You can also set the fan speed. 1 Select the operating mode and fan speed. Set the operating mode selection dial to. . . High fan speed Between HIGH and LOW Low fan speed Result: HI COOL MED COOL LOW COOL 2 The air conditioner starts up in Cool mode. The fan starts up at the speed selected. You can change modes at any time. 27°C ~ 23°C To adjust the temperature, turn the temperature control dial to the desired position. Possible temperatures: Between 18°C and 29°C inclusive. Result: The air conditioner starts cooling if the room temperature is higher than the selected temperature. 29°C ~ 27°C 23°C ~ 18°C 3 To control the direction of the air flow, refer to page 6. Airing Your Room If the atmosphere in your room is stale, you can air it using the Fan feature and if necessary, evacuate the stale air outside. 1 If you wish to evacuate stale air outside, push the ventilation lever on the front of the unit to the right and the open position ( ). The air conditioner does not cool Check that the correct operating mode has been selected. Dust may be blocking the air filter; refer to page 7 for cleaning instructions. Check that there is no obstacle blocking the air flow into or out of the unit. Odours are permeated in the room during air conditioning Air the room. E-8 Technical Specifications ENGLISH Design and specifications are subject to change without notice. Model AW05F05EA AW05F05BA AW05F05AA Power Supply 220-240V~, 50Hz 220V~, 60Hz 115V~, 60Hz E-9 Installation Before installation, be sure to check the installation area for the air conditioner, and drain hose. Checkpoints prior to installation 1 Check the cabinet and front grille of the unit for any harmful defects such as scratches. - Refer to the specifications on the label attached to the unit. Installation Conditions 1 As the unit is heavy, the wall or window of the installation area should have sufficient strength and durability for operation of the air conditioner, and for prevention of any vibration or noise. If it is weak, reinforcement work should be performed separately. 2 It is advisable to install the air conditioner in the north or west side to prevent the effect of direct sunlight. When installing it in the south or east side due to unavoidable circumstances, it is advisable to install the sunshade to prevent the direct sunlight. [. . . ] In this case, take care not to cause any hindrance to the flow of outside air. 3 When installing the air conditioner, be sure to obtain sufficient space on the rear side of the unit for smooth flow of air. When operating the air conditioner in closed areas such as inner building with cooling operation, and result in trouble with the unit. [. . . ]