User manual LG DLG5966S

[. . . ] Select a lower temperature (if necessary) . 12 Emptying the condensed water container . 16 Power failure - Emergency door release . 28 2 IMPORTANT SAFETY INSTRUCTIONS , WARNING - To reduce the risk of fire, electric shock, or injury when using your appliance, follow basic precautions, including the following: Read all instructions before using the appliance. [. . . ] ^ Turn the program selector to "Finish". ^ Press the "START" button. ^ Press the "Door" button to open the door. ^ Clean the lint filter before or after each use (see "Cleaning the lint filter". ) ^ Press the "On/Off" button to turn off the dryer. 11 Dryer care Cleaning the lint filter The lint filter must be cleaned before or after every program. Before cleaning the tumble dryer, disconnect the machine from the power supply. Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the dryer. They will damage the surface. Cleaning the exterior and the control panel ^ The exterior and the control panel can be cleaned with warm water and liquid dish soap applied with a soft sponge. ^ Wipe dry using a soft cloth. Cleaning the drum and stainless steel parts ^ Open the door and remove the lint filter. ^ Wipe the lint off the filter with your hand, do not use any sharp objects!^ Any lint remaining in the hollow part of the door can be removed through the gap at the bottom with a dust brush or vacuum. ^ Return the lint filter and close the door. The lint filter can be rinsed with hot water if necessary. ^ Dry the lint filter before putting it back in place. What if Possible fault Fix Repeat the program selection procedure in the correct sequence, see "Using the dryer". ­ The "ON/OFF" button is pressed in. ­ The machine is plugged in and the fuse or circuit breaker has not tripped. the tumble Check whether the "On" dryer fails to start indicator lights up. failure to start may be due to an incorrect program selection procedure. If the "On" indicator lamp does not illuminate, check that: . the laundry is not dry enough? The load consisted of dissimilar items (size and fabrics). Small loads or individual items may cause the program to terminate prematurely. The load was too large for the "Load size - Half" position. Press the "Load size - Full" button when drying larger loads. Make sure that the laundry is thoroughly spun before drying. . the drying times are too long? The lint filter is clogged. [. . . ] Minor discrepancies do not, however, have an adverse effect on operation. The stacking kit, part # 12 996 026, is available from your Miele dealer or the Miele Technical Service Department. ^ The machine can be leveled by turning the legs clockwise or counterclockwise as necessary. 24 Installation Changing the decor panel Note: The door should be closed when installing the decor panel. ^ On the door lock side remove the 4 screws (3 on the side and 1 underneath) and the door strip. ^ Loosen the remaining 7 screws on the lower and side decor strips until the decor panel can be bowed slightly and taken out. [. . . ]