User manual LG DLG7188RM

[. . . ] 3 Appearance & design . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Operating your dryer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Additional Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Caring for your dryer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] After removing package, you will check the product has no problem and is properly installed. Check the dryer is well balanced by using a leveller. In order to check this, you can see and adjust legs which are suppose to stay put. Check some major parts such as water container, condenser, control panel and drum. It is needed to operate 5 minutes drying to make sure drum inside gets warm. Clean the Lint Filters and empty water container. The lint filter should be cleaned after each load. 10. Turn off the Dryer. Press the ``Power'' button. Clean the lower lint filter. CAUTION - Be careful of the fact that filter should not be torn when using a vaccum cleaner. If there is a little residue buildup on filter, you can scrub lint screen with the brush to remove. - If you want to open the door while dryer is operating, please press the Start/Pause button first, wait until drum completely stops and then open the door. 12 O perating your dryer Rack Dry Apply models : TD-C70210E/215E The dryer Rack is placed inside the dryer like the picture. Remove and discard packing material before use, The Rack Dry is designed for use with items that you do not want to tumble dry including sweaters and delicate fabrics. F Note Check the lint filter and remove any lint accumulated from items dried on the Rack. To use the Rack Dry : Operating your dryer 1. Insert wire edge to the drum centre. 2. Clean the filter by using a vacuum cleaner or rinsing under the tap. 2. - Push the filter all the way down to avoid Interference with the door. Press the Start/Pause button. WARNING The condensed water is not suitable for drinking. CAUTION Wash the lint screen in warm, soapy Water. Dry thoroughly and replace. 15 C aring for your dryer Condenser F 4. Draw the condenser out by inserting a finger into a hole down the front of condenser. (Don't forcefully treat condenser. ) Condenser is also a very important part for efficient drying performance result so it needs a special care from you. It is recommended that condenser be cleaned three or four times a year. 1. Open condensing cover by using a coin or flat blade screwdriver. Caring for your dryer 5. Clean the condenser completely under the tap letting water to flow through. Open sealing cover by turning a locking lever. < Front > Sealing cover < Side > 3. Release the both locking levers turning towards each other. [. . . ] The drying time for a load will vary depending on the heat setting, the size of the load, the type of fabrics, the wetness of the clothes and the condition of the lint filter. Check the door and sealing cover is dirty and damaged. Try a shorter drying time and remove items while they still retain a slight amount moisture. To avoid shrinkage, please carefully follow the care and use instructions for your garment, because some fabrics will naturally shrink when washed. [. . . ]