User manual LG DT-585NW

[. . . ] · It is dangerous to alter or modify the unit's characteristics in any way. · The appliance must be installed in accordance with the relevant national legislation. · Should repairs be necessary, contact the nearest authorized Repair Service Center. Unauthorized servicing can be dangerous. [. . . ] In this mode, fan speed is selected automatically by the appliance and cannot be set manually. Note: - When operating in very cold rooms, the appliance may defrost automatically, momentarily interrupting normal operation. During this operation, it is normal for the noise made by the appliance to change. - In this mode, you may have to wait a few minutes before the appliance starts giving out hot air. - In this mode, the fan may operate for short periods, even though the set temperature has already been reached. Note: With high humidity conditions the display could show " Empty the internal circuit as shown in the para" graph "END OF SEASON OPERATIONS" 10 Operation SMART MODE GB The appliance chooses automatically whether to operate in air conditioning, fan or heating (certain models only) mode based on the set temperature and current room temperature. To set this mode: · Press the MODE button a number of times until the SMART symbol appears. For safety reasons, when the appliance is operating in heating mode, the fan speed could differ from the set speed. BOOST FUNCTION Ideal for the summer to cool rooms rapidly. To set this mode: · Press the button. The appliance operates in air conditioning mode at maximum fan speed. While this function is selected, it is not possible to set the temperature or change fan speed. Programming start up · Press the button. The start-up time and message ( ) flashes on the remote control display. · Press the or buttons to set the time you want the appliance to start up. · When that time is reached, press the OK button to confirm. The message ( ) appears on the remote control display and the symbol is displayed on the appliance to indicate that the timer is active. Programming shutdown · Press the button. The shutdown time and message ( ) flash on the remote control display. · Press the or buttons to set the time you want the appliance to shut down. · When that time is reached, press the OK button to confirm. The message ( ) appears on the remote control display and the symbol is displayed on the appliance to indicate that the timer is active. 15 Self-diagnosis SELF-DIAGNOSIS The appliance has a self diagnosis system to identify a number of malfunctions. Error messages are displayed on the appliance display. IF. . . IS DISPLAYED, WHAT SHOULD I DO? LOW TEMPERATURE (frost prevention) The appliance is fitted with a frost protection device to avoid excessive formation of ice on internal components. The appliance starts up again automatically when the defrosting process is completed. See page 18 "END OF SEASON OPERATIONS" FULL TANK (empty the internal tank) If this is displayed, contact your local authorized service centre. [. . . ] IF THIS OCCURS, WAIT 6 HOURS BEFORE TURNING THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. (After the unit has been on its side, oil needs to return to the compressor to ensure proper function. Without allowing the unit this time (6-24 hours) The unit may function for only a short time, and then the compressor will break down from lack of oil). This appliance is equipped with a 3 prong grounded plug. The plug must be connected into an outlet that is properly installed and grounded in the accordance with all local codes and ordinances. [. . . ]