User manual LG DV256K

[. . . ] REGULATORY INFORMATION: FCC Part 15 This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his expense. [. . . ] MANUAL: Use [Near] or [Far] button to select the DC Iris level. DC Iris level are set by one parameter unit. AGC (Automatic Gain Control) Setting If the images are too dark, change the maximum [AGC] value to make the images bright. Select [AGC] option on the [EXPOSURE] menu. Use [Near] or [Far] button to select a mode. WDR/BLC setting Use WDR/BLC option to set the options for BLC or WDR camera. Select [WDR/BLC] option on the [EXPOSURE] menu. Use [Near] or [Far] button to select a mode then press [Open] or [Close]. WDR LEVEL: WDR (Wide dynamic range) feature can be very helpful to cope with very challenging lighting conditions. It is capable of capturing both of the dark part and bright part and combining the differences into a scene to generate a highly realistic image as original scene. Set the WDR level (LOW, MIDDLE, HIGH) BLC LEVEL: Camera's backlight compensation feature helps alleviate issues of visibility in high contrast areas. Set the BLC level (LOW, MIDDLE, HIGH) HSBLC: Use for masking brightness of the specific area to view the subject more clearly. (-100 to 100) ONE PUSH: If you select the ONE PUSH mode, you will be able to set up the White Balance automatically using [Open] or [Close] button. 27 DAY/NIGHT Setting 1. 2. Select [DAY/NIGHT] option on the [CAMERA SET] menu. Use [Near] or [Far] button to select the mode. AUTO: You will be able to change the Day/Night mode automatically. - D/N LEVEL: Use [Near] or [Far] button to select a level. DWELL TIME: Use [Near] or [Far] button to select a dwell time. NIGHT: Black-and-white mode enabled. NOTE If you set the AGC to [OFF] on the [EXPOSURE] menu, the AUTO mode of the DAY/NIGHT function is not available and [---] mark is displayed. 28 3D-DNR Setting 1. If pictures are not clear due to brightness, use this function to reduce the noise of picture. Use [Near] or [Far] button to select an option. If you set the AGC to [OFF] on the [EXPOSURE] menu, the [3D-DNR] function is not available. When you use this function, the afterimage may occur. Color Setting You can switch the displayed picture to grayscale or color. 1. 2. Select [COLOR] option on the [CAMERA SET] menu. Use [Near] or [Far] button to change a color effect. [. . . ] After Alarm has been cleared and finished the dwell time, it moves to the HOME POSITION and spend the dwell time at that position. NOTE During the dwell time for alarm, you can not control the controller. Mode Change the observe position to the alarmed position then return to the 46 Alarm In Setting 1. Select one of the alarms in option on the [ALARM SET] menu. [. . . ]