User manual LG DVD-2310P

[. . . ] * Install the screw to attach the wall mount so that it can be assembled at the center from both ends of the studs. Use of stud finder, a separate device, is recommended. * Install the product only on a vertical wall. The manufacturer is not responsible for issue from installing the product on severely wall or on the ceiling. [. . . ] * Keep the included accessories out of reach of babies or children as it can cause safety issues including suffocation from swallowing the parts. * Make sure screws are tight against the wall, but do not overtighten. * Be careful not to install a TV that exceeds the weight restrictions of the wall mount. * Be careful with the tools used during installation to prevent accidents or damage. 3 ENGLISH Installation method - Tools you will need : Phillips head "+" driver(Manual or motorized) Ø4mm drill bit for wood or steel / Level / Stud finder / Drill. You may also need an 8mm socket wrench or an 8mm drill bit for concrete. 1 Separating the TV bracket 1 3 Safety pin 2 <Work procedure> 1. After expanding the wall mount forward as shown in Fig. 1, separate the safety pin from the wall mount as shown in Fig. Separate the set bracket as shown in Fig. 3. 2 Attaching the mounting bracket on the TV Make sure the screws are fully tightened to the bracket and display. If the screws will not fully tightened, they might be too long or the wrong size. VESA 100X100 / VESA 200X100 is supported. But, do not change 2 or more locations from the designated spot. Assemble the wall mount screw on 1 left and 1 right location on the top part and 1 left and 1 right location on the bottom part. At this time, use a "+" driver (Manual or motorized) or 8mm wrench to tighten the screw so that the wall, wall bracket and screw are completely pressed against one another. 5 ENGLISH 3 How to attach to masonry walls <When mounting to wooden studs> 76mm drywall 406mm wood stud drywall a. Locate and mark the centers of the wall studs using a stud finder. After aligning the wall bracket on the wall where the center of the wood stud is marked, mark the location of the screws and then remove the wall bracket. Use a level to make sure your screw marks are level. Use the 4mm drill bit for wood to drill holes with the depth of 76mm or above where the wall mount screw location is marked on the wall. Tighten the wall mount screws for the wall bracket on the drilled hole. At this time, tighten the screw so that the wall, wall bracket and the wall mount screw are pressed against one another. [. . . ] At this time, tighten the screw so that the wall, wall bracket and the wall mount screw are pressed against one another. (Drywall can be damaged when tightened with excessive force, please be careful. ) When tightening the screw use the "+" driver (Manual or motorized) or 8mm wrench. 5 How to assemble the wall mount support and display - Always install the display with 2 or more people. Safety pin After mounting the display, insert the safety pin as shown. If the safety pin is not fixated as shown in the picture, the display can fall. After the install is finished, pull the bottom part of the display to verify the product is attached securely. [. . . ]