User manual LG EL-21W

[. . . ] Keep children away from the unit. 5 ALWAYS ensure that the power cable is in good condition. If the power cord is damaged in any way, it must be replaced by an authorized service technician. Do not use an extension cord with this or other appliance. 6 Do NOT attempt to repair the unit yourself. If it is damaged in any way, contact: An authorized service center The dealer from whom you purchased the air conditioner. 7 Do NOT place any blocking objects in front of the unit. [. . . ] You can also set the fan speed. 1 If necessary, press the (On/Off) button. The operating mode indicator (COOL or FAN) on Result: the unit comes on. The air conditioner starts up in the mode selected when the unit was last used. air Theunit conditioner is fitted with a protection mechanism to prevent the from being damaged when it is started immediately after being: Plugged in Stopped It will start up automatically after about three minutes. 2 If the COOL indicator is not lit up on the unit: Press the button on the remote control or Press the MODE button on the unit one or more times until the COOL indicator lights up The unit beeps each time you press MODE. Result: The air conditioner starts up in Cool mode. 3 You can change modes at any time. To adjust the temperature, press the or button on the remote control one or more times until the required temperature is displayed. To adjust the temperature, press the or button on the unit one or more times until the required temperature is displayed. Possible temperatures are between 18°C and 30°C inclusive. Each time you press the temperature buttons: Result: ­ The temperature is adjusted by 1°C and displayed on the control panel ­ The unit beeps The air conditioner starts cooling if the room temperature is higher than the selected temperature. 4 To set the fan speed to. . . Press the button on the remote control. or Press the on the unit until the indicator lights up Press the button on the remote control. or Press the on the unit until the indicator lights up Press the button on the remote control. You can select the Off timer only when the air conditioner is on. 1 Check that the air conditioner has been switched on; if necessary, press the (On/Off) button. 2 Set the operating time by pressing: Timer on the remote control or Timer on the unit one or more times. Possible times are between 1 hour and 24 hour inclusive. Result: The remaining time is displayed and decreased by 1 hour automatically to indicate the remaining time. The air conditioner switches off automatically when the operating time reaches zero. You can change the setting mode, fan speed, and air flow direction after setting the Off timer. To Cancel the Off Timer To cancel the timer, press: Timer on the remote control or unit one or more times until " " is displayed. Topic Power failure Recommendation If a power failure occurs when the air conditioner is operating, the unit is switched off. When the power returns, the air conditioner starts up again automatically. Temperature and Humidity Ranges The following table indicates the temperature and humidity ranges within which the air conditioner can be used. Mode Cooling Indoor Temperature 21°C to 32°C approx. The automatic protection feature may be triggered and the air conditioner stopped. A water leakage or some other malfunction may happen if the heat exchanger freezes. Water may condense on and drip from the surface of the unit if it is used for long periods. Outdoor Temperature 21°C to 54°C approx. [. . . ] Check that the power cable is plugged into a wall socket and the socket is switched on, if necessary. Check that the operating mode indicator (COOL or FAN) on the unit is lit up; if necessary press (On/Off) on the remote control or unit. Check that there are no obstacles between you and the unit. Replace the remote control batteries if necessary. [. . . ]