User manual LG FLATRON L1510S

[. . . ] Height The PDP Display can normally operate only under 2000m(6562 feet) in height. It might abnormally function at a place over 2000m(6562 feet) in height, so do not install and operate there. Heat on the top of the PDP Display The top side of the product may be hot after long periods of use as heat dissipates from the panel through the vent hole in the upper part of the product. This is normal and does not indicate any defect or operation failure of the product. [. . . ] Press the or button to select Sound, then press the ENTER button. Select the required option by pressing the or button, then press the ENTER button. Available options: Mode, Equalizer, SRS TS XT, Auto Volume, Internal Mute, Sound Select, Reset When you are satisfied with your setting, press the ENTER button. Press the EXIT button to exit. Sound Mode Equalizer SRS TS XT Auto Volume Internal Mute Sound Select Reset : Custom : Off : Off : Off : Main 4 5 Move Enter Return < If Game Mode is On > Sound Mode: Standard/Music/Movie/Speech/Custom Mode : Custom You can select the type of special sound effect to be used Equalizer when watching a given broadcast. SRS TS XT : Off Auto Volume : Off Choose Standard for the PDP Display standard Internal Mute : Off factory settings. Sound Select : Main Choose Music when watching the music videos or Reset concerts. Move Enter Return Choose Speech when watching a show that is mostly dialog(i. e. , news). Choose Custom to recall your personalized settings. You can select these options simply by pressing the S. MODE button on the remote control. Equalizer: Balance/100Hz/300Hz/1kHz/3kHz/10kHz The PDP Display has several settings which allow you to control Equalizer the sound quality. R/L Sound Balance Adjustment: To adjust the sound balance of the R/L speakers. You can set the Month, Day, Year, Hour, and Minute directly by pressing the numeric buttons on the remote control. In the event of a power interruption or the set being turned off at the supply, the settings for the Clock will be lost. Sleep Timer You can select a time period of between 30 and 180 minutes after which the PDP Display automatically switches to standby mode. - Select the preset time interval (Off, 30, 60, 90, 120, 150, 180) by pressing the or button. Timer1 / Timer2 / Timer3 You can set the On/Off timers so that the PDP Display will switch on or off automatically at the time you select. - Press the or button to select the desired item below. Press the or button to adjust to the setting. On Time : Select hour, minute, and No/Yes. (To activate the On time, set to Yes. ) Off Time : Select hour, minute, and No/Yes. (To activate the Off time, set to Yes. ) Repeat : Select Once, Everyday, Mon - Fri, Mon - Sat, or Sat - Sun. Volume : Select the desired volume level. [. . . ] If you cannot solve the problem using the instructions below, note the model and serial number of the PDP Display and contact Samsung at 1-800-634-8770. No sound or picture Check that the power cord has been connected to a wall socket. Check that you have pressed the (Power) button (On/Off) on the front panel or press the ON button on the remote control. Check the picture contrast and brightness settings. [. . . ]