User manual LG GBF62PZHEN

[. . . ] Read this owner's manual thoroughly before operating the appliance and keep it handy for reference at all times. This manual may contain images or content different from the model you purchased. This manual is subject to revision by the manufacturer. The following safety guidelines are intended to prevent unforeseen risks or damage from unsafe or incorrect operation of the appliance. [. . . ] When the freezer temperature goes too high due to power failure, the freezer temperature LED lamp blinks and an alarm sounds. If the temperature is sufficiently cold, the - When the refrigerator is turned on. - When the freezer compartment gets too warm. - When there is a power outage that lasts for a long period of time. - When large amounts of warm food are placed in the freezer compartment. - When the freezer door is left open for too Press the lever 1 of the water dispenser to get cold water. If you open the fridge door while water is If the cup rim is small, water may splash out Use a cup with a rim of over 68 mm in diameter when dispensing water. Water Dispenser Tank 1 Open the cap (small cover) on the top of the water tank. 2 Fill the water tank with potable water and The water tank can hold up to 2. Keep children away from the dispenser to prevent children playing with or damaging the controls. To clean the water dispensing system, flush the water through the dispenser about 5 minutes. If you open the freezer door while water is being dispensed, the water supply will stop. Children should not be allowed near the dispenser tank. If the child drops the water dispenser tank while it is completely filled with water, injury may occur. Do not fill the water tank with drinks other than water or fill with hot water. Do not apply excessive force or impact when removing or assembling the water dispenser tank. Doing so can cause appliance damage or injury. Before using the water dispenser tank after installing the appliance, it should be washed before filling it with water. Check if the water dispenser tank has been placed on the appliance correctly. If it is not assembled correctly, water may leak from the tank into the appliance. If there is no water in the water dispenser tank, the cold water function of the dispenser cannot be used. Check if there is water in the water dispenser tank and then fill it with water if there is not. [. . . ] Normal Operation Appliance is not resting evenly on the floor. Floor is weak or uneven or leveling legs need to be adjusted. Appliance with linear compressor was moved while operating. If the compressor does not stop rattling after three minutes, turn the power to the appliance off and then on again. [. . . ]