User manual LG GC-151SFB

[. . . ] If fast cubes are required, set the control to the maximum cooling position. (Be sure to rest the control to the desired position after cubes have been produced. ) Ice cube tray is flexible. If the ice cube try is frozen hard to the evaporator surface, run a little water or lukewarm water. [. . . ] To make ice cubes in a hurry or to keep icecream frozen in the freezer compartment, set dial to 6 or 7. The dial does not have to be set exactly on the numbers. The thermostat does not operate in stages, but continuously. CLEANING AND MAINTENANCE The refrigeration does not require any maintenance, because the motor is completely sealed and self-lubricating. To clean the inside of the refrigerator, use a soft cloth with water, mild soap suds, or a mild detergent. Wash ice cube trays, drip tray, an shelf in a mild solution of detergent and dry with a soft towel. Stain on the outside can also be removed with a soft towel or a mild detergent. 6 Note Never use brushes, gasoline , acids, chemical thinner, turpentine, or benzine for cleaning any part of the refrigerator. Boiling water or benzine is especially harmful for plastic and rubber. LAMP REPLACEMENT 1. Unplug the power cord from the outlet. 3. Remove the lamp by turning it counterclockwise as shown in the figure at right. 4. Assemble in reverse order of disassembly. Replacement bulb must be the same specification as original. 7 IMPORTANT WARNINGS ACCESSIBILITY OF SUPPLY PLUG 7 The refrigerator-freezer should be so positioned that the supply plug is accessible for quick disconnection when accident happens. SUPPLY CORD REPLACEMENT If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. REPOSITIONING THIE DOOR HINGE Your Freezer is designed with a reversible door so that is may open from either left or right. It is best to reposition the door hinge as necessary at the outset since it is inconvenient to do so later. To change the door hinge please refer to the diagram below and proceed as follows:--1. Remove all loose fittings from inside the appliance. 2. Carefully lay the appliance on its back on the original packing (You will need assistance to achieve this). Take care not to damage the pipework by keeping it clear of the floor. 3. Unscrew and remove the Adjustable Foot (A) 4. Remove the Lower Hinge (D) by unscrewing the 2xBolts(B) 5. Remove the Leg(H)by unscrewing the bolt fixing it(C). 6. Gently pull the door downwards to remove it. 7. Before refitting the door, swap the Hinge Cap (F) by prising it from its current location and repositioning it on the other side of the door. Care should be taken not to damage the adjacent surfaces when removing the Hinge Cap 8. Unscrew the Upper Hinge pin (G) and screw it into the opposite side hole in the top of the cabinet. [. . . ] We decide whether to make repairs, exchange or replace parts. Exchanged or replaced parts are our property. The original warranty period is not prolonged if a refrigerator is repaired or certain parts are replaced. [. . . ]