User manual LG GH24NS90

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an Authorized Service Center for help. [. . . ] DVD+R : Mitsubishi Kagaku Media, Verbatim are recommended. DVD+RW : Mitsubishi Kagaku Media, Verbatim are recommended. DVD-RAM : Maxell, Panasonic are recommended. DVD+R DL : Mitsubishi Kagaku Media, Verbatim are recommended. DVD-R DL : Mitsubishi Kagaku Media, Verbatim are recommended. * Compatibility problem in write/read function may occur with media depending on the media manufacturing quality. * For DVD±R 24x support media: Mitsubishi Kagaku Media. * Upon the media condition or some of user's environment the maximum speed sometimes could not be guaranteed. 2 * Occasionally CD-R and CD-RW discs written by a CD-R/RW drive cannot be read by other CD drives*. These unreadable discs may need to be read using the CD-R/RW drive they were created with The disc written using the CD-R/RW drive might not be readable by CD-ROMs other than Multi-read compatible (UDF compatible) CD-ROMs Multiread compatible (UDF compatible) CD-ROMs are: 1. particularly those including Video playback) may require a considerably increased specification PC to give acceptable results. While this Super Multi DVD Rewriter can read DVD-video discs, decoding them to display on your pc's monitor requires separate MPEG decoding that is done by separate hardware (either an MPEG decoder card or MPEG decoding done by your video card), or separate software that you install to do MPEG decoding. For further details, refer to the documentation that comes with MPEG software. Location and Function of Controls Front Panel Rear Panel 4 1 23 1 2 1. SATA Data Connector (7 pin) 3 Installing the Drive Before installing the drive, please note the following points. You will need the following: · A screw driver of a suitable size to fit the securing screws for the drive unit. · The manual for the computer, so you can find the mounting positions for the SATA cable. Turn off all peripheral appliances of the computer and the computer itself, and disconnect their power cords from the wall sockets. Discharge any static electricity on your person by touching the computer covers, etc. Removing the Computer Cover Make sure all peripheral devices of the computer and the computer itself are turned off, and then remove the cover. Refer to the manual for the computer for details about removing the cover. NOTE : There may be sharp edges inside the computer so take care to avoid injury. Mounting the Drive 1. Remove the 51/4 drive bay panel from the computer. Refer to the manual for the computer for details. Do not apply excessive pressure to the cables inside the computer. If there is not enough space behind the drive, connect the SATA and other cables before securing the drive. NOTE : This is a general installation guide. [. . . ] Take care not to use worn, cracked, damaged, warped or poor quality CD-ROMs, as this may cause damage to your drive. Check the clear plastic on the center of the disc, cracks here are the main cause of disc crush. Do not play CD-ROMs which are a nonstandard (I. e. non-circular)shape, such as heart shaped discs, or discs in the shape of a business card. [. . . ]