User manual LG GH7155XKQ

[. . . ] Use of controls or performance of procedures other than those specified herein may result in hazardous radiation exposure. WARNING : To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Industry Canada requirement This class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. FCC COMPLIANCE STATEMENT Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] JVC, Mitsubishi Kagaku Media, TDK are recommended. DVD+R : Mitsubishi Kagaku Media, That's, Maxell are recommended. DVD+RW : TDK, Mitsubishi Kagaku Media, Ricoh are recommended. DVD±R DL : Mitsubishi Kagaku Media, Verbatim are recommended. DVD-RAM : Maxell, Mitsubishi Kagaku Media are recommended. * Compatibility problem in write/read function may occur with media depending on the media manufacturing quality. * For DVD±R 22x support media: Mitsubishi Kagaku Media, That's are recommended. * For Optimal writing, 80 pin E-IDE cable and Pentium IV 2. 4GHz or faster are recommended. * Upon the media condition or some of user's environment the maximum speed sometimes could not be guaranteed. 2 * Occasionally CD-R and CD-RW discs written by a CD-R/RW drive cannot be read by other CD drives*. These unreadable discs may need to be read using the CD-R/RW drive they were created with The disc written using the CD-R/RW drive might not be readable by CD-ROMs other than Multi-read compatible (UDF compatible) CD-ROMs Multiread compatible (UDF compatible) CD-ROMs are: 1. particularly those including Video playback) may require a considerably increased specification PC to give acceptable results. When several (up to four) EIDE devices are connected, each must be set in a unique way. Specific knowledge of hardware and software is necessary to install the drive. SL: Slave MA: Master NOTE : If two peripheral devices with the same settings are both connected to the Primary or to the Secondary EIDE bus, the host computer may fail to run or may malfunction. Careful attention is necessary. CS: Cable Select (CSEL) 4 NOTE : Only one jumper should be installed on the jumper connector. If more than one jumper is installed, the drive may malfunction or be damaged. Master/Slave setting is determined by jumper installation on the Jumper Connector. The following table shows the possible jumper settings. Name MA (Master) SL (Slave) CS (Cable Select) Function Drive set as Master Drive set as Slave Drive mode set by CSEL on the host IDE interface C S S L M A If you use CSEL setting, the MASTER/SLAVE setting will be made automatically, depending on the hardware configuration. For more details refer to the manual of your computer. PC Connection The Super Multi DVD Rewriter connects to the motherboard of the host computer using an IDE interface cable. You may connect the Super Multi DVD Rewriter as a Slave or Master device, depending on your computer. To Install as a Master Drive To install the drive as a Master, the jumper can be left as supplied from the factory. Master drive (Booting hard disk) Master drive (Super Multi DVD Rewriter) (Jumper left as Master) Master drive (Super Master drive (Booting hard disk) Multi DVD Rewriter) (Jumper left as Master) DIGITAL AUDIO DG DIGITAL AUDIO DG ANALOG AUDIO RG L CS M SLA INTERFACE 39 40 1 2 POWER +5 GND +12 - OR Motherboard Primary connector ANALOG AUDIO RG L CS M SLA INTERFACE 39 40 1 2 POWER +5 GND +12 DIGITAL AUDIO DG ANALOG AUDIO RG L CS M SLA INTERFACE 39 40 1 2 POWER +5 GND +12 Primary connector Slave drive (Other IDE drive) Secondary connector Secondary connector NOTE : A hard disk is normally installed as the Primary Master on the EIDE (ATAPI) interface. Other EIDE peripheral devices such as hard drives and Super Multi DVD Rewriters are then set differently. Run Add New Hardware in Control Panel to let PC search again for new device. Software Install the appropriate CD Recording Authoring Software before using this unit. * Please uninstall any previous CD burning software you may have loaded on your PC in order to prevent possible compatibility issues. [. . . ] · Is there enough free space on the CD, DVD and DVD-RAM disc?· Does writing fail even using the simulation test?· Is the disc loaded in the drive with the read/write surface facing the right direction?(label up) · Is the drive installed in the correct orientation? [. . . ]