User manual LG GL-T272QMAMSQMG

[. . . ] You will find your model number on the bottom right side of the air conditioner. Model # Serial # 2 Contents USING PARTS Safety precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Viewing your air conditioner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 MA duct type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Using your air conditioner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If so, turn off the unit and switch off the circuit breaker. · Press the Power button on the remote control to turn the unit off and switch the circuit breaker off. Then, switch it on again. The fan speed does not change. Odors permeate in the room during operation. The air conditioner makes a bubbling sound. Water is dripping from the air flow blades. Remote control is not working. The air conditioner does not turn on or off with the wired remote control. The wired remote control does not operate. The indicators of the digital display flashes. OPERATIONRANGES The table below indicates the temperature and humidity ranges the air conditioner can be operated within. MOdE OPERATIONALTEMPERATURE INdOOR 21°C to 32°C OUTdOOR 21°C to 54°C INdOOR HUMIdITY 80% or less IFOUTOFCONdITIONS Condensation may occur on the indoor unit with risk to have either water blow off or drops on the floor. Condensation may occur on the indoor unit with risk to have either water blow off or drops on the floor. COOLING DRYING 21°C to 32°C 21°C to 54°C - If the cooling operation is used at over 32°C (indoor temperature), it does not cool at its full capacity. 13 INSTALLATION PARTS Safety precautions (Carefully follow the precautions listed below because they are essential to guarantee the safety of the equipment. ) WARNING · Always disconnect the air conditioner from the power supply before servicing it or accessing its internal components. Always disassemble the electric lines before the refrigerant tubes. Upon receipt, inspect the product to verify that it has not been damaged during transport. If the product appears damaged, DO NOT INSTALL it and immediately report the damage to the carrier or retailer (if the installer or the authorized technician has collected the material from the retailer. ) After completing the installation, always carry out a functional test and provide the instructions on how to operate the air conditioner to the user. Do not use the air conditioner in environments with hazardous substances or close to equipment that release free flames to avoid the occurrence of fires, explosions or injuries. The air conditioner should be used only for the applications for which it has been designed: the indoor unit is not suitable to be installed in areas used for laundry. 14 Our units must be installed in compliance with the spaces indicated in the installation manual to ensure either accessibility from both sides or ability to perform routine maintenance and repairs. The units' components must be accessible and that can be disassembled in conditions of complete safety either for people or things. For this reason, where it is not observed as indicated into the Installation Manual, the cost necessary to reach and repair the unit (in safety, as required by current regulations in force) with slings, trucks, scaffolding or any other means of elevation won't be considered in-warranty and charged to end user. Power suPPly line, fuse or circuit breaker Always make sure that the power supply is compliant with current safety standards. Always install the air conditioner in compliance with current local safety standards. Always verify that a suitable grounding connection is available. Verify that the voltage and frequency of the power supply comply with the specifications and that the installed power is sufficient to ensure the operation of any other domestic appliance connected to the same electric lines. Always verify that the cut-off and protection switches are suitably dimensioned. [. . . ] k Screws on terminal block must not be unscrewed with the torque less than 12 kgf·cm. 28 Selectingcompressedringterminal Silver solder B D d1 E F L d2 t Norminal Norminal Standard Standard Standard dimensions dimensions Standard Allowance Allowance Allowance Allowance dimension dimension Min. for cable for screw dimension (mm) (mm) (mm) (mm) (mm) (mm) (mm) (mm) (mm) (mm2) 4 6. 6 +0. 3 +0. 2 1. 5 ±0. 2 3. 4 1. 7 ±0. 2 4. 1 6 16 4. 3 0. 7 4 8 -0. 2 0 4 6. 6 +0. 3 +0. 2 2. 5 ±0. 2 4. 2 2. 3 ±0. 2 6 6 17. 5 4. 3 0. 8 4 8. 5 -0. 2 0 +0. 3 +0. 2 4 4 9. 5 ±0. 2 5. 6 3. 4 ±0. 2 6 5 20 4. 3 0. 9 -0. 2 0 CAUTION Select the power cable in accordance with relevant local and national regulations. Wire size must comply with local and national code. For the power cable, use the grade of H07RN-F or H05RN-F materials. [. . . ]