User manual LG GL-T302QMASWQTM

[. . . ] Instead, they are requested to directly contact a designated service center or the outlet at which the product was purchased. x Never spill any kind of liquid into the unit. Should this happen, unplug or main switch off the unit and contact an authorized service center. x Do not insert anything between the air outlet blades because the inner fan may be damaged and could cause injury. [. . . ] x The indoor unit beeps. 2 Press the Result: button. x The temperature and fan settings are adjusted automatically. x The air conditioner cools or heats the room as quickly as possible. x After 30 minutes, the air conditioner is reset automatically to the previous mode, temperature and fan settings. But, if you press the button in DRY or FAN mode, it will change to AUTO mode automatically. 3 If you wish to stop the Turbo function before the end of the 30-minute period, press the Result: button again. The air conditioner is reset automatically to the previous mode, temperature and fan settings. 4 To control the direction of the air flow, refer to page 17. E-12 Removing Excess Humidity If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. 1 If necessary, press the Result: (On/Off) button. x The operation indicator on the indoor unit lights up. x The air conditioner starts up in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped It will start up normally after 3 minutes. CAUTION 2 If the is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. Result: Note x The indoor unit beeps each time you press the x The air conditioner runs in DRY mode. button. 3 To adjust the temperature, press the button one or more times until the required temperature is displayed. 1 To set the operating time, press the button one or more times until the required time is displayed. Possible time is between 0. 5 hour and 24 hour inclusive. 2 Press the Result: (Set/Cancel) button to complete the setting. x Blinking of the timer indicator stops. x The air conditioner will switch off automatically when the counter displayed on the remote control reaches the set time and disappears the Off timer setting. Example If you would like to turn the air conditioner on after 2 hours and to operate it for 2 hours: 1. Press the Note button until `2. 0 Hr' is displayed. button until `4. 0 Hr' is displayed. (Set/Cancel) button. You can see or change the setting mode and/or the temperature by pressing the button or the button after setting the Off timer. To Cancel the Off Timer Press the Note (Set/Cancel) button. x If you press the button when the On Timer is set, the On Timer is also cancelled. E-19 Setting the Sleep Timer The Sleep Timer can be used when you are cooling or heating your room to switch the air conditioner off automatically after a period of six hours. Note If you wish to switch the unit off at a specific time, refer to page 19. 1 2 Make sure that you have selected either COOL or HEAT mode. x The air conditioner will be controlled as indicated in the illustrations below. Cooling The desired temperature is increased by 1°C every hour. When it has been increased by 2°C (after 2 hours), the temperature is maintained for 4 hours. Heating The desired temperature is decreased by 1°C every hour. [. . . ] x Dust may be blocking the air filter guard; refer to page 24 for cleaning instructions. x Check that there is no obstacle in front of the outdoor unit. x Check that the required temperature has been set correctly. x If the air flow is directed upwards, use the remote control to direct it downwards. [. . . ]