User manual LG GR-051GSF

[. . . ] Consult a qualified electrician or service person if the grounding instructions are not completely understood, or if you have doubts on whether the appliance is properly grounded. Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer. [. . . ] To ensure proper air circulation around the fridge -freezer, please maintain sufficient space on both the sides as well as top and maintain at least 2 inches (5 cm) from the rear wall. If the floor is not even, adjust the feet by using the leveling screw at the front edge of the cabinet. If the front is slightly higher than the rear, the door can close more easily. Check that the hot air caused to warm air from the rear of the appliance circulates without obstruction. If not, it could cause the output of the refrigerating unit to increase and this will result in a higher rate of energy consumption. Therefore, confirm that ventilation grill is never covered or blocked. When installing with top table(free standing), push the refrigerator until the air circulating hole of top table nearly reaches the wall. When installing without top table, align the door front edge to the front edge of kitchen furniture. This appliance should be connected to the mains AC 220~240V , 50 Hz. You must connect this appliance only to the power socket with grounding complying with the related regulations and only an approved expert should install this appliance. In case of installing the door handle, refer to a figure enclosed with it in a product package. ⷠClean refrigerator including inside devices with clothes or lukewarm water. You may use commercial detergent for tableware. Regularly clean the heat exchanger on the rear side of refrigerator using a smooth brush so that accumulations of dusts and residues. Do not disrupt expansion from the inside and cause increased energy consumption. Any damage to the heat exchanger or other events leading to the exposure of the refrigerant to the environment, should be avoided because of potential environment and health risks. When you plan to be away for an extended period, remove all food, disconnect the power cord, clean the interior thoroughly, and leave the door OPEN to prevent odor formation. Most power failures are corrected in an hour or two and will not affect your refrigerator temperatures. However, you should minimize the number of door openings while the power is OFF. Remove all items inside the refrigerator or securely fasten all loose items. To avoid damaging the leveling screw, turn them all the way into the base. ⷠThe Anti-condensation pipe is installed around the front side of fridge-larder to prevent dewing. [. . . ] A large quantity of food was placed inside the fridge compartment. The temperature inside the refrigerator is too cold Foods with strong odors should be tightly covered or wrapped · Wipe it with a dry towel · Light lamp needs replacing. Moisture forms on cabinet surface Interior light does not work Your refrigerator is designed with a reversible door, so you may open from either left or right. It is best to reposition the door hinge as necessary at the outset since it is inconvenient to do so later. [. . . ]