User manual LG GR-3324L.EPLQPOR

[. . . ] Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. *) Please contact your local authority for further details. Attention: Your product is marked with this symbol. It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collection system for these products. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. [. . . ] If water 7 Do not place a vessel with watercause electric shock. penetrates into the unit, electrical insulations may deteriorate and not block 8 Dotroubles. It may cause insufficient performance or the operation turn the circuit breaker off before 9 Be sure to stop cleaning. A fanandrotating inside the unit and you mayperforming any maintenance or is get injured. 10 Do not splash or pour water directly on the unit. Water can cause electrical shock or equipment damage. 11 This appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance. CAUTIONS FOR LOCATION / INSTALLATION Make sure to connect the air conditioner to power supply of the rated voltage and frequency. Use of a power supply with improper voltage and frequency can result in equipment damage and possible fire. Do not install the unit in a place where inflammable gas may leak. Install the unit in a place with minimal dust, fumes and moisture in the air. Arrange the drain hose to ensure smooth drainage. The unit generates a beep when it receives the signal. Make sure there is no curtain or other object between the remote control and the unit. The remote control can send signals from up to 7 metres away. CAUTION Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely affect its operation. If the signal receiver window is exposed to direct sunlight, close a curtain to block the light. Using a fluorescent lamp with a quick starter in the same room may interfere with transmission of the signal. The unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. Do not leave the remote control in direct sunlight or near a heater. Also, protect the unit and remote control from moisture and shock which can discolour or damage them. E-7 ENGLISH BASIC OPERATION 1 Press the MODE button to select the operation mode. AUTO HEAT COOL DRY 2 Press the ON/OFF button to start operation. 2 5 3 1 4 The red OPERATION lamp ( unit will light. button to set the desired temperature. AUTO/DRY MODE The temperature can be changed in 1C increments within the range of 2C higher to 2C lower from the temperature automatically determined by the air conditioner. COOL/HEAT MODE The temperature can be set within the range of 18 to 32C. TIPS ABOUT AUTO MODE In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature when the unit is turned on. 4 Press the FAN button desired fan speed. AUTO SOFT LOW to set the HIGH Modes and Temperature Settings Room temp. Automatic Operation at operation start-up Mode Temperature Setting Below 21C HEAT 23C 21C-24C DRY Room Temp. at start-up 24C-26C COOL 24C 26C-28C COOL 25C Above 28C COOL 26C In the DRY mode, the fan speed is preset to AUTO and cannot be changed. 5 To turn off the unit, press the ON/ OFF button again. The red OPERATION lamp ( unit will turn off. [. . . ] If the ONE-HOUR OFF TIMER is set while the unit is not operating, the unit will operate for an hour at the formerly set condition. If you wish to operate the unit for another hour before the ONE-HOUR OFF TIMER is activated, press the ONE-HOUR OFF TIMER button again during operation. E-12 AUXILIARY MODE Use this mode when the remote control is not available. Lift the front panel of the indoor unit and press the AUX. The red OPERATION lamp ( ) on the unit will light and the unit will start operating in the AUTO mode. The fan speed and temperature setting are set to AUTO. TO TURN OFF Press the AUX. [. . . ]