User manual LG GR-584YLS

[. . . ] Particularly, keep children away from the indoor unit. Do NOT overload wall sockets or extension cables. If the remote control will not be used for a long time, remove the batteries, and keep in remote control case. Users of this product are cautioned not to attempt repair of this product at their own discretion. [. . . ] IMPORTANTE The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Switched on x Stopped lt will start up normally after a three-minute rest period. 2 If the AUTO indicator is not displayed, press the MODE button one or more times until it appears. Result: x The indoor unit beeps each time you press MODE. x The air conditioner starts up in AUTO mode. x The standard temperature is set automatically. Note In AUTO mode, the optimum fan speed is selected automatically and cannot be changed. x You can change modes at any time. 3 To control the air flow direction when necessary, refer to page 15. E-10 Cooling Your Room You must select the COOL mode if you wish to adjust the: xCooling temperature xFan speed when cooling 1 If necessary, press the ON/OFF( ) button. Result: x The power indicator on the control panel comes on. x The operation mode previously set is displayed. x The air conditioner starts up in the mode selected when the unit was last used. IMPORTANTE The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Switched on x Stopped It will start up normally after a three-minute rest period. 2 If the COOL indicator is not displayed, press the MODE button one or more times until it appears. Result: x The indoor unit beeps each time you press MODE. x The air conditioner starts up in Cool mode. x The air conditioner starts heating, provided that the room temperature is lower than the desired temperature; the fan will, however, operate. x During heating, the operating indicator ( ) on the control panel comes on. x During defrosting, the defrosting indicator ( ) on the control panel comes on. 5 Select the fan speed by pressing the FAN SPEED button one or more times until the required setting is displayed: Low Medium High To select fan speed by remote control, press LOW, MID or HIGH buttons. Result: x Each time you press FAN SPEED, the indoor unit beeps. x For the first three to five minutes, the fan operates very slowly unit the air has been sufficiently warmed. once the correct temperature has been reached, the fan is automatically set to the required speed. 6 7 To control the direction of the air flow refer to page 15. If you find that the room is not warm enough, set the Auxiliary Heater switch to the ON position. (option) See `Operating Recommendations' on page 17 for more information. Result: x The heater indicator( ) on the control panel comes on. E-12 Changing the Room Temperature Quickly The turbo function cooling/heating is used to cool or heat your room as quickly as possible. Example : You have just come home and find that the room is very hot. You wish to cool it down as quickly as possible. ENGLISH The turbo function operates for 30 minutes with the maximum settings before returning automatically to the mode and temperature previously selected. [. . . ] Mode Heating Cooling Outdoor Temperature 0°C to 21°C approx. Indoor Temperature 28°Cor less Indoor Humidity - 21°C to 32°C approx. 80% or less If the unit is used for long periods at a high humidity level, water may condense on and drip from the surface of the unit. Cleaning Your Air Conditioner To get the best possible use out of your air conditioner, you must clean it regularly to remove the dust that accumulates on the air filter. IMPORTANTE Before cleaning your air conditioner, ensure that you have switched off the breaker used for the unit. 1 2 Pull the air inlet grille lightly and pull out the air filter in an upward direction to release them. [. . . ]