User manual LG GR-B359-PTQA

[. . . ] · It is dangerous to alter or modify the unit's characteristics in any way. · The appliance must be installed in accordance with the relevant national legislation. · Should repairs be necessary, contact the nearest authorized Repair Service Center. Unauthorized servicing can be dangerous. [. . . ] M. G Keep the air hoses as short and free of curves as possible to avoid constrictions. SEMI-PERMANENT INSTALLATION If required, your appliance can also be installed semi-permanently (Fig. H). MAX100 cm MAX 39 inches MIN 35 cm MAX 14 inches M 30 cm 12 inches When the hose 12 is not fitted, the hole can 30 cm 12 inches H be closed with the flange cap 11 . Proceed as follows: · Drill a hole (ø134mm / 5, 27 in. ) in an outside wall or through a window pane. Respect the height and dimensions of the hole given in figures M and I. NOTE: When installing the air conditioner semi-permanently, you should leave a door slightly open (as little as 1 cm) to guarantee correct ventilation. 6 C o n t ro l p a n e l THE CONTROL PANEL S Q O P N I T L M H G GB A B C R D E F DESCRIPTION OF THE CONTROL PANEL A ON/OFF button B MODE selection button Air conditioning, dehumidifying, fan. C Fan speed selection button (MAX/MED/MIN) D Timer button E Programmed operation increase temperature/time button F Programmed operation decrease temperature/time button G Display Displays the temperature values set and the programmed operating time H Timer in operation indicator light I/L/M Fan speed lights N Fan mode light O Air-conditioning mode light P Dehumidifying mode light Q Alarm light R Remote control receiver S Light: the inner temperature is shown on the display T Light: the outdoor temperature is shown on the display Never turn the air conditioner off by unplugging from the outlet. Always press the button, then wait for a few minutes before unplugging. This allows the appliance to perform a cycle of checks to verify operation. 7 O p e ra t i o n TURNING THE APPLIANCE ON Before plugging the appliance check the black cap on the back of the unit is correctly inserted in the drainage hose 10 . Plug into an outlet. Two lines appear on the display indicating that the appliance is in stand-by. When turned on, the air conditioner starts operating in the same mode as when it was turned off. Press the MODE button (B) until the light corresponding to the desired mode lights up: Light (O): air-conditioning mode Light (P): dehumidifying mode Light (N): fan mode AIR CONDITIONING MODE Ideal for hot muggy weather when you need to cool and dehumidify the room. The display shows the inner temperature: the light (S) turns on. To modify the set temperature, push the (E) or (F) button to reach the desired temperature. The light (H) flashes until the appliance turns off as programmed. At the set time, the air conditioner shuts down and remains in standby. To cancel the timer programme, press the timer button (D) again. Light (H) stops flashing. 9 Using the remote control unit (some models only) MODELS WITH REMOTE CONTROL · Point the remote control at the receiver on the air conditioner. The remote control must be no more than 16, 4 ft (5 metres) away from the appliance (without obstacles between the remote control and the receiver). · The remote control must be handled with extreme care. Do not drop it or expose it to direct sunlight or sources of heat. MAX 16, 4 ft MAX 5 metres DESCRIPTION OF THE REMOTE CONTROL 22) "ON/OFF" button 23) Increase /Decrease button for temperature/programmed use 24) "MODE" button 25) "TIMER" button 26) Fan speed selection button (MAX/MED/MIN). 27) °F/°C scale button 22 23 26 24 25 27 Inserting or replacing the batteries · Remove the cover on the rear of the remote control; · Remove the old batteries, if present. · Correctly insert two new L03 "AAA" 1, 5V batteries (see the instructions inside the battery compartment); · Replace the cover. If the remote control unit is replaced or discarded, the batteries must be removed and disposed of in accordance with current legislation as they are harmful to the environment. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. Batteries may explode or leak. TURNING THE APPLIANCE ON Plug the appliance into the mains. [. . . ] (After the unit has been on its side, oil needs to return to the compressor to ensure proper function. Without allowing the unit this time (6-24 hours) The unit may function for only a short time, and then the compressor will break down from lack of oil). This appliance is equipped with a 3 prong grounded plug. The plug must be connected into an outlet that is properly installed and grounded in the accordance with all local codes and ordinances. Do not modify the plug provided with the appliance. [. . . ]