User manual LG GR-B399-PTQA

[. . . ] · Do not install the appliance in rooms containing gas, oil or sulphur. · Keep the appliance at least 50 cm away from flammable substances (alcohol etc) or pressurised containers (e. g. · Do not rest heavy or hot objects on top of the appliance. · Clean the air filter at least once a week. [. . . ] · Screw the end of the hose without adapter to the adapter previously mounted on the appliance (see fig. A). Vertically sliding window · Fit the bar grille 15 to the bar 17 and fix with the four screws provided 18 (fig. · Place the bar 17 in the window and extend it for the width of the window (fig. · Once the bar has been extended, fix it by screwing up the remaining two screws supplied. D). A 18 Pre p a r i n g f o r u s e EN · Open the window or French window C D slightly and position the outlet shown in fig. G 19 as · Place the air conditioner near the window. Insert the assembled air exhaust hose 12 in the grille on the bar 17 (fig. Make sure the air exhaust hose is not blocked. · When the appliance is not in use, the hole in the bar can be closed with the bung 16 provided. G Keep the air hoses as short and free of curves as possible to avoid bottlenecks. E Double window · Fit the window outlet 19 to the air exhaust hose 12 pre-assembled as shown in fig. F. 2 1 F 19 Pre p a r i n g f o r u s e AIR CONDITIONING WITH INSTALLATION If required, your appliance can also be installed semi-permanently (Fig. · Fit the flange accessory provided 11 in the hole. To set this function correctly: · Press the MODE button a number of times until the dehumidifying symbol appears. °C NOTE: In this mode, with room temperature above 25 degree C, the fan speed is adjustable. If the temperature is below, fan speed is selected automatically by the appliance and cannot be set manually. FAN MODES When using the appliance in this mode, the air exhaust hose does not need to be attached. To set this function correctly: · Press the MODE button a number of times until the fan symbol appears. · Select the required fan speed by pressing the button. There are 3 speeds available: High speed: for maximum fan power; °C °C Medium speed: reduces noise levels but still maintains a good level of comfort; Low speed: for silent operation. °C PLEASE NOTE: To change the unit of measurement for the displayed temperature, press the and buttons together for 3 seconds. °C °F 23 Setting the timer SETTING THE TIMER The timer can be used to delay when the appliance comes on or goes off. This avoids wasting electricity by optimising operating periods. How to programme delay ON · Plug the appliance into the mains socket. · Use the (F) or (C) buttons to set the number of hours delay before the appliance comes on. They increase or decrease the time in steps of an hour. The appliance can be set to come on within the next 24 hours. Five seconds after the timer has been set, the display dims and the setting is memorised. [. . . ] Press the ON/OFF button of the remote control (17) (when turned on, the air conditioner starts operating in the same mode as when last turned off). Press the MODE button (18) button to select the required mode: AIR CONDITIONING (COOLING) DEHUMIDIFYING FAN ONLY The light corresponding to the selected mode lights up on the control panel. For air conditioning/dehumidifying/fan only settings and programming the timer, see the paragraphs on pages 22-23. 25 Tips To get the best from your air conditioner, follow these recommendations: · close the doors and windows of the room to be air conditioned. The only exception is when the appliance is installed through a hole in the wall. [. . . ]