User manual LG GR-L217TVQ

[. . . ] When using the air conditioner for infants, children, elderly, bedridden, or disabled people make sure the room temperature is suitable for those in the room. Inserting objects can result in injury due to the high speed rotation of internal fans. Ground the air conditioner without fail. Do not connect the grounding wire to gas pipe, water pipe, lightning rod or telephone grounding wire. [. . . ] ⷠSetting the temperature lower than necessary during cooling operation will result in increased power consumption. Blocking direct sunlight during cooling operation will reduce power consumption. ⷠClose the windows and doors during cooling opeation (and heating operation with models AY-X08BE/AYX10BE/AY-X13BE). The indoor unit still consumes a small amount of power when it is not operating. The built-in protective device may prevent the unit from operating when used out of this range. ⷠCondensation may form on the air outlet if the unit operates continuously in the COOL or DRY mode when humidity is over 80 percent. NOTE: Actual units might vary slightly from those shown above. (The heat mode symbol is provided only on models AY-X08BE/AY-X10BE/AY-X13BE) (The heat mode symbol is provided only on models AY-X08BE/AY-X10BE/AYX13BE) H TIMER OFF INDICATOR Indicates the preset time for off timer or one-hour off timer. Batteries in 2 Insert making surethe compartment, the ± and -- polarities are correctly aligned. ⷠThe display indicates "AM 6:00" when batteries are properly installed. The battery life is approximately one year in normal use. The indicator panel will change each time you press the DISPLAY button in the following manner. The room temperature and POWER MONITOR are displayed. When the room temperature or the outdoor temperature is displayed, the POWER MONITOR will light up in 4 levels (3 levels for DRY mode), to indicate the operation power. When the air conditioner is operating at maximum power in the COOL (and HEAT for AYX08BE/AY-X10BE/AY-X13BE)mode, "Power" will light and "Eco" will turn off on the indicator panel. The displayed temperatures are rough estimates and may vary from the actual temperatures. ⷠTemperature display ranges Room temperature: 0°C ~ 40°C ( is displayed when less than 0°C and when higher than 40°C) Outdoor temperature: -9°C ~ 45°C ( is displayed when less than -9°C and when higher than 45°C) · Is displayed during the first minute of operation while the temperatures are being detected. ⷠOnly the room temperature can be displayed when the unit is not in operation. The adjusted position will be memorized and will be automatically set to the same position when operated the next time. The adjustment range is narrower the SWING range in order to prevent condensation from dripping. Manual adjustment of the vertical adjustment louvre can cause the unit to malfunction when the remote control is used for the adjustment. ⷠWhen the vertical adjustment louvre is positioned at the lowest position in the COOL or DRY mode for an extended period of time, condensation may result. [. . . ] ) at the signal receiver 3 Point the remote control press the TIMER SET window on the unit and The unit will generate a beep when it receives the signal. The unit will turn on prior to the set time to allow the room to reach the desired temperature by the programmed time. (The heat mode symbol is provided only on models AY-X08BE/AY-X10BE/AY-X13BE) You can use the ON and OFF timers in combination. And resume operation (With the same mode and temperature settings) to bring the room temperature to the desired level by 7:00 a. [. . . ]