User manual LG GR-53W41GVF

[. . . ] · The manufacturer can not be responsible for problems caused by ignoring these safety and caution instructions. · This dishwasher is designed for normal household use. · Do not use the dishwasher for industrial and commercial use, or other purpose. · The appliance is not intended for use by young children or infirm persons without supervision. [. . . ] The required amount of salt is set up according to how hard your tap water is. Filling with Salt Fill the regenerating salt container before starting the washing program. Once you have filled with salt you must run the "Pre wash" or "Quick" course immediately to remove salt and salt water around the tub in order to prevent corrosion. · Remove lower rack and unscrew the cap of salt container. · Before using your dishwasher for the first time, it is necessary to Pour 1. 5kg of salt and 1 liter of water in to the container. Use a funnel for ease and clean filling, ensuring that coarse salt or regenerating salt intended for dishwashers is used. · After filling, wipe off any spilled salt to seal the cap properly. · Screw the cap tightly to prevent any suds from penetrating into the container. Step 4. Adding Rinse Aid For filling To fill the Rinse Aid chamber, rotate the round cap counter clockwise and remove. Fill the container to the maximum level with a good quality Rinse Aid, then replace and lock the cap. The Rinse Aid is automatically dispensed during the final rinse cycle. The dosage is factory set to suit most installations. Before adjusting, ensure that the rack is empty. You can change the position of the upper rack by lifting the rack upward, into the upper position, or by pulling on the two levers on either side of the rack to move it down to its lower position. We recommend that where possible the upper rack remains level. And when you pull the rack upward, hold the middle location of the upper rack ( marked position) After adjusting the rack levels, check that the spray arm is free to rotate. D1417W(L, M, T, B, C, D)F(B, U) D1418W(L, M, T, B, C, D)F(B, U) Your upper rack can be raised or lowered to cater for different size of crockery. Before adjusting, ensure rack is empty of all crockery and side the rack out. Reinsert the rack in the chosen position. Fitting the rack back into the standard position reduces the space between the upper and lower rack. After adjusting, check that the spray arm is free to rotate. WARNING Before adjusting, ensure the rack is empty of all crockery. Otherwise crockery may be damaged or you may be injured. 18 H OW TO USE AND OPERATE 6. Adding Detergent · Detergent must be put into the detergent chamber before starting every program. [. . . ] (Water is not pumped away. ) Possible Causes · The drain hose is kinked. (Washing motor or Drain motor) Solution · Straighten hose(s). · If you can not solve the problem, call for service. · If you can not solve the problem, call for service. The display shows "IE" code. · Water is not supplied. [. . . ]