User manual LG GS-3159-PVJZ

[. . . ] * When installing/using the wall mount, be cautious of product damage and avoid accidents. * If you have not fully read and understood the installation manual, do not install the product and contact the dealer to have a specialized installer install the product for you. *  ven if you are not a specialized installer, it is advantageous to have experience in mechanical or E construction field in completely understanding this manual and installing the product. [. . . ] T * Install the screw to attach the wall mount so that it can be assembled at the center from both ends of the studs. Use of stud finder, a separate device, is recommended. * Install the product only on a vertical wall. The manufacturer is not responsible for issue from installing the product on severely wall or on the ceiling. * Keep the included accessories out of reach of babies or children as it can cause safety issues including suffocation from swallowing the parts. * Make sure screws are tight against the wall, but do not overtighten. * Be careful not to install a TV that exceeds the weight restrictions of the wall mount. * Be careful with the tools used during installation to prevent accidents or damage. 3 ENGLISH Installation method - Tools you will need : Phillips head "+" driver(Manual or motorized) Ø4 mm drill bit for wood or steel / Level / Stud finder / Drill. You may also need an 8 mm socket wrench or an Ø8 mm drill bit for concrete. 1 Separating the TV bracket 1 2 3 Safety pin <Work procedure> 1. and, set the angle adjusting part to face S upward.  lign the wall mount bolt to the hole and tighten it. Then, fasten the bolts at torque of 45 kgf/cm - 60 kgf/cm. A 4 How to install the wall mount Wall mount screw → If the screw cannot be assembled in the designated location inevitably, it can be assembled by rearranging to the closest location. But, do not change 2 or more locations from the designated spot. → Assemble the wall mount screw on 1 left and 1 right location on the top part and 1 left and 1 right location on the bottom part. → this time, use a "+" driver (Manual or motorized) or 8 mm At wrench to tighten the screw so that the wall, wall bracket and screw are completely pressed against one another. 5 ENGLISH 3 How to attach to masonry walls 5 How to assemble the wall mount support and display - Always install the display with 2 or more people. Safety pin →  fter mounting the display, insert the safety pin as shown. If the safety pin is not fixated as shown in the picture, A the display can fall. →  fter the install is finished, pull the bottom part of the display to verify the product is attached securely. A →The clearance from the wall is 14 mm (32LE46* : 36 mm) for this product. [. . . ] A →The clearance from the wall is 14 mm (32LE46* : 36 mm) for this product. → n using cables or accessories not provided with the wall mount, make sure to keep a certain distance from the I wall so that excessive force is not applied on cables or accessories. 6 How to level the Display If the product is not leveled after the installation, you can rotate the display up to 5 degrees. ± 5° 7 - Arrange the cables as shown in the picture. [. . . ]