User manual LG GSA-H62N

[. . . ] (If they are not fastened securely enough, the TV may tilt forward after being installed. ) Do not fasten the screws with too much force; otherwise they may be worn out and get loosened. Tidying cables Only 32/37/42LS57**, 65LM62**, 32/42/47LM669* 1 Gather and bind the cables with the Cable Holder. NOTE Remove the stand before installing the TV on a wall mount by performing the stand attachment in reverse. [. . . ] Yy Whenever you handle TV, Protection pad should be covered with side of TV. (Depending on model) Protection Pad yy Hold the top and bottom of the TV frame firmly. Make sure not to hold the transparent part, speaker, or speaker grill area. 18 ASSEMBLING AND PREPARING Mounting on a table 1 Lift and tilt the TV into its upright position on a table. --  eave a 10 cm (minimum) space from the L wall for proper ventilation. Securing the TV to a table Fix the TV to a table to prevent from tilting forward, damage, and potential injury. To secure the TV to a table, insert and tighten the supplied screw on the rear of the stand. (Only 32/37/42LS57**, 32/42/47LM669*) ENGLISH ENG 10 cm 10 cm m 10 c 10 cm (Only 32/37LM62**, 32LM64**, 32LM660*) 2 Connect the power cord to a wall outlet. CAUTION yy Do not place the TV near or on sources of heat, as this may result in fire or other damage. m4 x 8 2EA  NOTE (Only 32/37LM62** , 32LM64** , 32LM660*) How to fix the TV to a table 1. Connect the Desk-mount Cables to the Stand Base using the Bracket Screws. When you attach the TV to other building materials, please contact qualified personnel. lG recommends that wall mounting be performed by a qualified professional installer. ENGLISH ENG CAUTION yy Disconnect the power first, and then move or install the TV. Yy If you install the TV on a ceiling or slanted wall, it may fall and result in severe injury. Use an authorised LG wall mount and contact the local dealer or qualified personnel. Yy Do not over tighten the screws as this may cause damage to the TV and void your warranty. Yy Use the screws and wall mounts that meet the VESA standard. Any damages or injuries by misuse or using an improper accessory are not covered by the warranty. 10 cm 10 cm 10 cm 10 cm Make sure to use screws and wall mount bracket that meet the VESA standard. Standard dimensions for the wall mount kits are described in the following table. Separate purchase(Wall Mounting Bracket) Model 32/37LS57** 32/37LM62** 32LM64** 32LM66** 200 x 200 M6 4 LSW200BX 42LS57** 42/47/55LM62** 42/47/55/60LM64** 42/47/55LM66** 42/47/55LM67** 42/47/55LM76** 400 x 400 M6 4 LSW400BX NOTE yy Use the screws that are listed on the VESA standard screw specifications. [. . . ] Connect the external device and the TV set with the euro scart cable as shown. To display images by using progressive scan, make sure to use the euro scart cable. Yy When watching digital TV in 3D imaging mode, TV out signals cannot be output through the SCART cable. (Only 3D models) yy If you set the 3D mode to On while a scheduled recording is performed on digital TV, monitor out signals cannot be output through the SCART cable, and the recording cannot be performed. [. . . ]