User manual LG GW-P207-FLQA

[. . . ] Electrical Connections (In the UK Only) Important The wires in this mains lead are coloured in accordance with the following code : GREEN AND YELLOW : EARTH BLUE : NEUTRAL BROWN : LIVE This appliance must be earthed As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows : The wire which is coloured Green and Yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol( ) or coloured Green or Green and Yellow. The wire which is coloured Blue must be connected to the terminal which is marked with the letter N or coloured Black. The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Red. If a 13 amp(BS 1363) plug is used, fit a 13 amp BS 1362 fuse. 1 3 3 6 9 10 11 11 12 13 13 23 24 24 24 25 25 25 26 26 26 28 29 30 32 32 33 Introduction Entry The model and serial numbers are found on the inner case or back of refrigerator compartment of this unit. [. . . ] Please contact with the local service center if warning continue to sound even after closing the door. Diagnosis (failure detection) function Diagnosis function automatically detects failure when failure is found in product during the use of refrigerator. If failure occurs at product, it does not operate though pressing any button and normal indication is not done. In this case, do not turn power off but immediately contact with the local service center. A lot of time are need for service engineer to detect the failed part if turning it off. How ice/cold water is supplied Water is cooled while stored in the water tank in the refrigerator compartment, and then sent to the dispenser. Ice is made in the automatic ice maker and sent to the dispenser divided into crushed or cubed form ice. NOTE It is normal that the water is not very cold at first. If you want colder water, add ice into the glass. · Cautions Throw away the ice (about 20 pieces) and water (about 7 glasses) first made after refrigerator installation. The first ice and water may include particles or odor from the feed water pipe or feed water box. This is necessary in case that the refrigerator has not been used for a long time. Children may push switch incorrectly bad or damage lamps. Be careful that food is not block the ice passage. If foods are placed at the entrance of ice passage, ice may not be dispensed. The ice passage may also be covered with ice powder if splinter ice is used only. This time, remove the ice powder accumulated. Never store beverage cans or other foods in ice storage bin for the purpose of rapid cooling. Such actions may damage the automatic ice maker. Never use thin crystal glass or crockery to collect ice. Such glasses or containers may be broken. Put ice first into a glass before filling water or other beverages. Water may be splashed if ice is added to existing liquid in a glass. Never touch a hand or other tools on ice outlet. [. . . ] When the first supply of ice is dropped into the bin, the dispenser should operate. Turn the freezer control to a higher setting so that ice cubes will be made. When the first supply of ice is made, the dispenser should operate. Open household water line valve and allow sufficient time for ice to be made. [. . . ]