User manual LG H19F34DT

[. . . ] has determined that this product meets the ENERGY STAR guidelines for energy efficiency. (Only H19F34DT model) P/NO : SAC30708026 (0805-REV02) www. lgcommercial. com WARNING / CAUTION FCC NOTICE To prevent fire or shock hazards, do not expose this product to rain or moisture. TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). REFER TO QUALIFIED SERVICE PERSONNEL. WARNING / CAUTION The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING/CAUTION Class B digital device This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] I If the 4:3 picture format is used; the fixed images on the sides of the screen may remain visible on the screen. This phenomenon is common to all TVs and is not covered by warranty. I 22 EXTERNAL EQUIPMENT SETUP Antenna Connection 1. How to connect 1 2 Connect the RF antenna out socket of the VCR to the A N T E N N A I N socket on the TV. Connect the antenna cable to the RF antenna in socket of the VCR. ANTENNA IN 1 M. P. I. S-VIDEO VIDEO L R ANT OUT OUTPUT SWITCH ANT IN 2. How to use I I Wall Jack Antenna 2 Set VCR output switch to 3 or 4 and then tune TV to the same channel number. Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner's manual. ) ( ) Composite (RCA) Connection 1. How to connect 1 AV IN AV IN11 S-VIDEO AUDIO ( MONO ) VIDEO RGB IN (P COMPONENT IN V Connect the A U D I O/V I D E O jacks between TV and VCR. Match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red) ANTENNA IN M. P. I. VIDEO 1 AUDIO AUDIO (RGB/ EXTERNAL EQUIPMENT SETUP 2. How to use I I Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner's manual. ) Select the A V 1 input source on the TV using the I N P U T button on the remote control. (Optoisolators isolate the control lines, and a transformer isolates the audio. There are no relays or inductive components in the control lines. ) pin No. Purpose 1 2 3 4 5 6 External TV On/Off switch. (Not used. ) External Channel Up switch or Data in. Common connection for control, data, and audio output. Impedance to earth ground is a 10-meg resistor in parallel with a 1 100 pf capacitor. Nominal 14-ohm source impedance with short circuit protection. Intended for a pillow speaker with a low-impe ance pad-type volume control. External Channel Down switch. Controlling the TV with Mechanical Switches Pin 4(common) is momentarily connected to pin 1, 3, or 6 via push-action switches to control On/Off and Channel Up/Down. These pins are at +13volts DC(when measured from pin4) with the switches open. Current draw is 8 mA when a switch is closed. [. . . ] I Ensure that the correct remote operating mode is set: TV, VCR etc. Power interrupted. I Power is suddenly turned off The video function does not work. I Is the power cord inserted into wall power outlet?I Check your antenna direction and/or location. [. . . ]