User manual LG HRF-C400FA

[. . . ] In the event of thunderstorms or powercuts, please pull out the aerial and mains plugs. Warning To prevent fire or shock hazard, do not expose the set to rain or moisture. Do not place anything containing liquid on top of the set, this may cause a fire or could give an electric shock. Service Never remove the back cover of the set as this can expose you to very high voltage and other hazards. If the set does not operate properly, unplug it and call your dealer. Aerial Connect the aerial cable to the socket marked on the back cover. For the best reception an outdoor aerial should be used. Location Position your set so that no bright light or sunlight falls directly onto the screen. [. . . ] Press the G button and then D / E button to select On or Off on the XD pull-down menu. Repeatedly press the MENU button to return to normal TV viewing. 16 Picture adjustment Eye (option) Eye is an optional function. Only a set with eye option can perform this function. In some models, the set will automatically adjust the picture according to the surrounding conditions. This will enable you to enjoy the most suitable picture according to the surroundings. Press the EYE/ * button to switch the eye function on or off. Off When the eye function is on, the most suitable picture is automatically adjusted according to the surrounding conditions. At this time the display in green does not appear continuously but the display in yellow appears each time the picture condition changes. MENU Note : a. The eye function is automatically switched off. EYE function is not available for RGB input source. PR VOL OK PR VOL Picture adjustment You can adjust picture contrast, brightness, colour intensity, sharpness and tint (NTSC input only) to the levels you prefer. Press the MENU button and then D / E button to select the Picture menu. Press the G button and then D / E button to select Contrast, Brightness, Colour or Sharpness. EYE/ Picture PSM XD Contrast Contrast Brightness Colour Sharpness { { { { { { { 100 ()O}{OOKOMENU 3. Press the G button to tune in a frequency on the X-wave menu. Use the number 0 to 9 or press the F / G button to match the TV's frequency and the FM receiver's. Sound PR VOL OK PR VOL SSM Turbo0Sound AVL Balance X-WAVE { { { { { SetOFreq { Off X-WAVE 88MHz 107MHz FM95. 0MHz }{0-9OOKOMENU ()O}{OOKOMENU Note: a. If the reception is poor or weak, select a different frequency. For best results, there should be no more that 5m (16. 4ft) between the TV and FM Receiver. In certain areas, the FM transmitter ability may be weak, such as near a broadcast tower. The reception sensitivity may depend on the kinds of receiver (FM radio). 19 Sound adjustment Sound output selection In AV mode, you can select output sound for the left and right loudspeakers. Repeatedly press the I/II/ button to select the sound output. L+R : Audio signal from audio L input is sent to left loud-speaker and audio signal from audio R input is sent to right loudspeaker. L+L : Audio signal from audio L input is sent to left and right loudspeakers. R+R : Audio signal from audio R input is sent to left and right loud-speakers. * Stereo/Dual reception When a programme is selected, the sound information for the station appears after the programme number and station name disappear. Broadcast Mono Stereo Dual On Screen Display MONO STEREO DUAL I Mono sound selection In stereo reception if the stereo signal is weak, you can switch to button twice. In mono reception the mono by pressing the I/II/ depth of sound is improved. [. . . ] MIX Displays the teletext pages superimposed on the TV picture. To switch the TV picture off press this button again. 1 4 7 MENU 2 5 8 0 3 6 9 PR PR TEXT/MIX/ TIME/ REVEAL/ ? X TIME When viewing a TV programme, press this button to display the time at the top right hand corner of the screen. Press this button again to remove the display. In the teletext mode, press this button to select a sub page number. [. . . ]