User manual LG HS200G CARACTERISTIQUES TECHNIQUES

[. . . ] Please read this manual carefully before operating your set. Record model number and serial number of the set. See the label attached on the bottom of the set and quote this information to your dealer when you require service. Model number : Serial number : DLP PROJECTOR OWNER'S MANUAL HS200 HS200G HS201 HS201G DLP PROJECTOR Warning This is a class A product. [. . . ] Press the , , , button to adjust the screen condition as you want and then press the OK button. · Resolution can be chosen between 768 resolution (1024x768/1280x768/1360x768, 60Hz) and 1050 resolution (1400x1050/1680x1050, 60Hz). To exit the menu display, press the RETURN button. RGB Config. Resolution Auto Configure Position Size Phase Reset Move Prev. 1024 x 768 1280 x 768 1360 x 768 · Using the Still Function 1. Press the STILL button on the remote control. * You can freeze the moving image. <Moving Image> <Still Image> 2. To exit STILL, press any button. * The STILL function will release automatically after approximately 10 minutes. 22 Function AUDIO Menu Options What is FM Wireless Audio? (HS200/HS200G only) FM Wireless Audio is a function to send out audio signals from the projector using FM frequency (88. 5 ~95. 5 MHz). The frequency of Projector and FM receiver should be same in order to output the sound from FM receiver normally. The signal can be received by using FM receiver within 3m of distance. Audio Signal 88. 5 ~95. 5 MHz < The recommended use range of FM receiver > Install projector and FM receiver without any abstacles as shown on the figure below. A FM receiver can be reached 5 m when the antenna length and direction are good. FM Receiver Receiving range Within 3m 45° 45° Front Projector 45° 45° < The recommended length of FM receiver Antenna > We recommend to use a rod antenna 0. 8 ~ 1. 5 m for better sound quality since audio noise can be detected when using under 0. 8m rod antenna. 23 Function Installing Instructions (HS200/HS200G Only) · · · · · · This product is for domestic use. If used in a medical institution, it may cause an error for medical equipments. Please do not use in a medical establishment. Please maintain the distance between the projector and FM receiver within 3m. The sound from FM receiver may not come out in the desired quality if the distance is more than 3m. Please adjust the location of FM receiver and its antenna and install them to where it shows a good condition of receiving reception. According to the installed location and environment, the receiving distance may become shorter and the sound may be interrupted due to: If If If If If If If an obstacle is located near the projector and FM receiver. an obstacle passes near by the projector and FM receiver. the FM receiver is installed Left, Right, or diagonal line of projector the Projector or the FM receiver is located inside of a rack made of metal. other FM transmitter equipment is working near at the same frequency. there is a radio broadcast on air at the same frequency. working in the dusty, humid, or high temperature environment. What do I do if the FM receiving signal is not good?(HS200/HS200G Only) · · · · · · · · Please adjust the antenna of FM receiver or move the location of FM receiver. If there is no Audio signal or low reception, within 55 seconds the FM Wireless Audio function will shut down automatically. Please check if the power of projector or FM receiver is on. Please check if there is any obstacle between the projector and FM receiver. [. . . ] Press the , buttons to move to DivX Reg. You can see the DivX registration code of the projector. · With a DivX registration code from other projector, playback of rented or purchased DivX file is not allowed. (Only DivX files matched with the registration code of the purchased projector are playable. ) The video or audio of a file converted based on a standard other than the DivX codec standard may be corrupted or unable to be played. Press the MENU or RETURN button to exit the menu screen. USB Photo List Music List Movie List DivX Reg. [. . . ]