User manual LG KRV-375FF

[. . . ] · This External Blu-ray Disc Rewriter is for use only with UL listed personal computers that have installation instructions detailing userinstallation of card cage accessory. i EU Conformity Notice LG Electronics hereby declares that this/these product(s) is/are in compliance with the essential requirements and other relevant provisions of Directive 2004/108/EC, 2006/95/EC, and 2009/125/EC. European representative : LG Electronics Service Europe B. V. The Netherlands (Tel : +31-(0)36-547-8888) CAUTION : CLASS 3B VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN. ADVARSEL : KLASSE 3B SYNLIG OG USYNLIG LASERSTRÅLING VED ÅBNING. [. . . ] When using digital video connections, the monitor and graphics card must support High-bandwidth Digital Content Protection (HDCP). Note that most monitors and graphics cards currently don't support HDCP. But, most High Definition TVs and multimedia monitors do support HDCP. Refer to the PC or graphic card maker's web site to see if your card supports HDCP. Some video cards that currently support HDCP: - Blu-ray Disc playback: Intel G45, ATI Radeon HD 2400, NVIDIA Geforce 7600GT or above - 3D playback: Intel G45, ATI Radeon HD 2400, NVIDIA Geforce 8800GT or above *When using ATI RadeonTM HD 1000 Series Graphic Card, some BLURAY movie title can not be played on Windows7 normally. It caused by giving up supporting the device driver of this Graphic Card by ATI RadeonTM. For more information, Please contact to customer service center or website of ATI RadeonTM. *1 Graphic card driver shall meet AACS compliance criteria. Please consult your graphics card vendor for proper driver solution. *2 HDCP (High Bandwidth Digital Content Protection): Required to view pre-recoded Blu-ray Discs which are copy protected. 3 Important precautions Follow these precautions when handling the drive or discs. Precautions Please note that the manufacturer of this equipment does not offer any warranty against data loss due to inappropriate installation, handling, direct or indirect damages. Connect the other end of the USB converter cable (or eSATA cable) to your computer. Connect the AC adapter plug to the power connector at the rear of the drive. Attach the AC adapter to the AC wall outlet. Make sure the power switch is turned on. When the computer is ready, confirm that the drive is detected. And then, insert the supplied software CD into the External Drive and install the software. eSATA cable or USB 2. 0 Converter cable NOTES · · · Please do not connect the AC adapter and USB 2. 0 converter cable by any means other than specified above. For optimal performance, using the `USB Booster Program' in the Software CD is recommended when you connect the USB cable. For optimal performance, using the SATA to eSATA Bracket is recommended when you connect your old Desktop PC. 6 Removing the USB converter cable The drive supports the plug and play(not swap) function of Windows, and can be removed and inserted by performing the following operation. Stop the application software being currently used. " of the taskbar located on your screen's bottom right 3. Click "Safely Remove USB Mass Storage Device-Drive[x:]". [. . . ] Disc crush can only occur when you use a damaged disc in the drive. It is an extremely rare occurrence, but there are steps which can be taken to prevent it. Always check your discs before inserting them into the drive. Take care not to use worn, cracked, damaged, warped or poor quality discs, as this may cause damage to your drive. [. . . ]