User manual LG L1006R

[. . . ] Dealer's Name Date Purchased s Staple your receipt to this page in the event you need it to prove date of purchase or for warranty issues. 1. Common Issues READ THIS MANUAL Inside you will find many helpful hints on how to use and maintain your air conditioner properly. Just a little preventive care on your part can save you a great deal of time and money over the life of your air conditioner. You'll find many answers to common problems in the chart of troubleshooting tips. [. . . ] Pull the filter in the same direction as the opening. 4 Clean the filter with warm, soapy water. The water should be below 40°C (104°F). 5 Rinse off and gently shake off excess water from the filter. Let it dry before replaceing it. Drainage The base pan may overflow due to high humidity. To drain the excess water, remove the drain cap from the back of the unit and secure the drainpipe. When pressing the drainpipe into place, apply force in the direction away from the fins to avoid injuring yourself. Drain pipe Drain cap 11 Remote Control Operations Air Purifying Filter (Optional) The Air Purifying filter behind the air filter should be checked and cleaned once every 3 months or more often if necessary. 1 After removing the Air Purifying Filter, pull slightly forward to remove the Air Purifying filter. mild detergent for 20~30 minutes. 2 Soak the Air Purifying Filter in water mixed with a 3 Dry the Air Purifying Filter in the shade for a day. (The moisture must be removed completely on this part. ) 4 Note the cuts of electric discharge lines. 5 Re-install the Air Purifying Filter to the original position. WARNING: Don't touch this Air Purifying Filter within 10 seconds after opening the inlet grille; it may cause an electric shock. least 3 minutes before resetting to the cooling operation again. RemoteAttach Drain Pan (Optional) How to Control Operations The air conditioner employs a proper drain method whereby the condensed water (moisture removed from the air) is drained to the outside. In very humid weather, (and for reverse cycle models in the reverse mode) excessive condensate water removed from the air may cause some water to collect. To remove this excess water you can install the drain pan as detailed below. 1 Take the drain pan which is located in the air discharge. · The top and bottom window sash must open sufficiently to allow a clear vertical opening of 15" from the bottom of the upper sash to the window stool. 25" to 36" 15" min (With frame curtain) Stool Offset 1 /2" to 11/4" Sill Interior wall 20 1/12" min. for Screw(Type B) 6 7 Attach the cabinet to the window stool by driving (Type B: Length 16mm (5/8 inch) the screws and below. ) through the front angle into window stool. Sill Support 2 Sash track 8 Pull each Frame Curtain fully to each window sash track, and repeat step 2. Front Angle Screw(Type B) Sill Support 2 6 9 Attach each Frame Curtain screws the window sash using (Type C). 5 7 CAUTION: Do not drill a hole in the bottom pan. The unit is designed to operate with approximately 1/2" of water in bottom pan. There is no need to add water if the pan is dry. Fig. 6 10 Slide the unit into the cabinet. 7) CAUTION: For security purpose, reinstall screws (Type A) at cabinet's sides. Screw(Type A) Power cord Screw (Type A) Fig. 7 11 Cut the Foam-Strip to the proper length and insert between the upper window sash and the lower window sash. 8 19 About 1/2" 12 Attach the Window Locking Bracket C screw . 9) with a Type Window locking bracket 12 Fig. 9 13 Attach the front grille to the cabinet by inserting the tabs on the grille into the tabs on the front of the cabinet. Push the grille in until it snaps into place. [. . . ] 24) to minimize the hazard of electric shock. The customer should have the wall receptacle and circuit checked by a qualified electrician to make sure the receptacle is properly grounded. 230, 208, and 230/208 VOLT UNITS These units are equipped with a three-prong grounding plug on the power supply cord, which must be plugged into a matching properly grounded three-prong wall receptacle for your protection against possible shock hazard. If such an outlet is not present, one must be installed by a qualified electrician in accordance with the National Electrical Code and local codes and ordinances. [. . . ]