User manual LG LAC-M5500

[. . . ] Do not become distracted by the vehicle while driving, and always be fully aware of all driving condition. Do not change settings, or any functions. Pull over in a safe and legal manner before attempting such operations. Do not use for many hours at extremely low or high temperature. [. . . ] Install the dash panel or adapter plate. Install the control panel to the unit. 4 5 6 3 1 2 Control panel 6 Connection diagram Before connecting, make sure that the ignition switch is set to OFF, and remove the battery # terminal to avoid short circuits. B 1 2 1 2 3 4 3 4 5 6 5 6 7 8 7 8 To Speaker To Vehicle B (Optional) r (Optional) A A A A A A A A A 2 PHONE MUTE (ORANGE) 8 GROUND(-) (BLACK) 6 DIMMER SWITCH DIMMER (PINK) 7 IGNITION SWITCH TO IGNITION (RED) 4 TO BATTERY(+) (YELLOW) 5 POWER ANTENNA (BLUE) 1 AMPLIFIER (Optional) BATTERY 1 2 3 C REMOTE ON (BLUE/WHITE) POWER Antenna 4 5 CONTROL RELAY 6 7 8 B B B B B B B B 1. 8. Violet : Rear Right + Violet/ Black Stripe : Rear Right ­ Gray : Front Right + Gray / Black Stripe : Front Right ­ White : Front Left + White/Black Stripe : Front Left ­ Green : Rear Left + Green/ Black Stripe : Rear Left ­ 7 A From antenna B To the wiring of the vehicle colors of leads. · BLACK: · ORANGE: · PINK: · RED: · YELLOW: · BLUE: This lead is for the ground connection. This lead is for the phone line connection. This lead is for the dimmer line connection. This lead is for connection to the power supply terminal when the ignition switch is set to ACC. This lead is for connection to the battery (back-up) terminal from which power is always supplied. This lead is for the power antenna connection. · BLUE/WHITE: This lead is for the remote amplifier on connection. C Speaker Connections 1 2 3 4 5 6 7 8 REAR FRONT FRONT R R L REAR L Connecting to Auxiliary Equipment (Optional) Connect the AUDIO OUTPUT jack of this unit to the AUDIO INPUT jack of the Auxiliary Equipment. FL (Front Left) FR (Front Right) RL (Rear Left) RR (Rear Right) To AUDIO OUT To AUDIO IN To AUDIO IN Amplifier 8 Basic operation Turning the unit on Press MUTE/PWR (POWER on the remote control) or any other button. Note When you insert the CD in the CD slot, the unit turns on. Turning the unit off Press and hold MUTE/PWR (POWER on the remote control). Selecting a source Press SRC S repeatedly to select a source. The indicator lights up in the following order. TUNER CD TUNER. . . Note You cannot select a source if a CD is not inserted. Adjusting the volume Rotate MUTE/PWR (Press VOLUME on the remote control) to adjust the sound level. Note When you turn the unit off, the current volume level is automatically memorized. Whenever you turn the unit back on, it will operate at the memorized volume level. Mute 1 2 Press MUTE/PWR (POWER To cancel it, press again. FM1 t FM2 t FM3 t MW(AM) B Auto Seek : Press - [b/B[ + (?m m/M M?When a station is received, searching stops. B Manual Seek : Press and hold - [b/B[ + (?m m/M M?on the remote control) until "MANUAL" appears, and then press it repeatedly. The frequencies move up or down step by step. Storing and recalling broadcast frequencies You can easily store up to 6 broadcast frequencies for later recall at the touch of a button. 1 2 3 Press BAND to select desired band you want to store. Press one of preset buttons 1-6 and hold until the beep sound. The number you have pressed will flash in the preset number indicator and then remain lit. The selected radio station frequency has been stored in memory. Repeat steps 1-3 to preset other stations. The next time, you press the same preset button, the radio station frequency is recalled from the memory. 4 Note · Up to 18 FM stations, 6 for each of three FM bands and 6 MW(AM) stations can be stored in the memory. [. . . ] ­ SCAN or SCAN disappear from the display window and the intro scan is cancelled. 2 Repeat The current selected tracks/files (1 RPT) or folder ( 1 2 3 RPT) on the disc is played repeatedly. ­ 1 RPT appears on the display window. CD MP3 WMA Press and hold RPT for about 2 seconds during playback. ­ RPT appears on the display window. [. . . ]