User manual LG LAC-M8400R

[. . . ] To ensure proper use of this product, please read this owner's manual carefully and retain for future reference should the unit require maintenance, contact an authorized service location (see service procedure). Use of controls, adjustments, or the performance of procedures other than those specified herein may result in hazardous radiation exposure. To prevent direct exposure to laser beam, do not try to open the enclosure. DO NOT STARE INTO BEAM. Caution: Protect this product from moisture. Caution: If the battery is disconnected or discharged, the preset memory will be erased and must be reprogrammed. 3 Before Use To ensure proper use of this product, please read this owner's manual carefully and retain for future reference. Notes on Discs Handling Discs Do not touch the playback side of the disc. [. . . ] Slide the unit and frame into the dash opening. Install the faceplate by sliding the right edge into position and then pushing the left edge closed. 6 5 4 2 3 7 Connections Connecting to the Car Before connecting, make sure that the ignition switch is set to OFF, and remove the battery terminal to avoid short circuits. PREPARATION A 1 GND (BLACK) 2 PHONE (ORANGE) B 3 DIMMER (PINK) DIMMER SWITCH 4 TO IGNITION (RED) IGNITION SWITCH 5 TO BATTERY. (YELLOW) 6 PWR ANT (BLUE) POWER ANTENNA BATTERY 1 1 2 2 3 4 5 7 REMOTE ON (BLUE/WHITE STRIPE) CONTROL RELAY 3 4 5 6 7 8 POWER AMPLIFIER (optional) C 6 7 8 WHITE (FL +) WHITE/ BLACK STRIPE (FL -) GRAY (FR +) GRAY/ BLACK STRIPE (FR -) GREEN (RL +) GREEN/ BLACK STRIPE (RL -) VIOLET (RR +) VIOLET/ BLACK STRIPE (RR -) 8 Connections Connecting to the Car From antenna To the wiring of vehicle Colors of leads 1 BLACK : This lead is for the Ground connection. 2 ORANGE : This lead is for the phone line connection. 3 PINK : 4 RED : This lead is for the Dimmer line connection. Speaker Connections PREPARATION L 1 2 3 4 5 6 7 8 R FRONT L REAR R C This lead is for connection to the power supply terminal when the ignition switch is set to ACC. 5 YELLOW : This lead is for connection to the Battery (back-up) terminal from which power is always supplied. 6 BLUE : This lead is for the power antenna connection. 7 BLUE/WHITE STRIPE : This lead is for the remote amplifier on connection. 9 Basic Operation Turning the unit on Press PWR or any other button on the front panel Adjusting the volume Use VOLUME to adjust the sound level. Press VOLUME (VOL. +/-) button on the front panel to increase or decrease the volume. OPERATION Turning the unit off Press PWR on the front panel to turn the unit off. Setting the clock 1. Press DISP and press DISP for more than 1 second. To cancel it press MUTE again. NOTE The unit cannot adjust the bass and treble in the EQ/XDSS on mode. XDSS (Extreme Dynamic Sound System) Press and hold the EQ/XDSS button to reinforce treble, bass and surround effect. 11 Radio Operation Listening to the radio stations 1. Press the PWR button to turn the unit on. - When you select a source the unit is turned on. Press the FUNC button to select the tuner. - Press the BAND button until the desired band is displayed, FM1, FM2, FM3, MW(AM). To perform seek tuning, press the SEEK(-/+) button with quick presses. - The tuner will scan the frequencies until a broadcast with strong enough reception is found. - You can cancel seek tuning by pressing the SEEK(-/+) button with quick presses. To perform manual tuning, press the TUNE(-/+) button with quick presses. - The frequencies move up or down step by step. NOTE · When the selected frequency is being broadcast in stereo, the " indicator will light. [. . . ] Turn the unit off and then on. REFERENCE Clean disc. Connect the cables correctly. The volume level is low. This unit is not firmly secured. Adjust the volume. Secure this unit firmly. 15 Specifications MP3 Disc compatibility with this unit is limited as follows: 1. [. . . ]