User manual LG LAC-M8410

[. . . ] Do not become distracted by the vehicle while driving, and always be fully aware of all driving condition. Do not change settings, or any functions. Pull over in a safe and legal manner before attempting such operations. Do not use for many hours at extremely low or high temperature. [. . . ] Violet : Rear Right + Violet/ Black Stripe : Rear Right ­ Gray : Front Right + Gray / Black Stripe : Front Right ­ White : Front Left + White/Black Stripe : Front Left ­ Green : Rear Left + Green/ Black Stripe : Rear Left ­ A A A A A A 2 PHONE MUTE (ORANGE) 8 GROUND(-) (BLACK) 6 DIMMER (PINK) 7 IGNITION SWITCH TO IGNITION (RED) 4 TO BATTERY(+) (YELLOW) 5 1 BATTERY POWER ANTENNA/REMOTE ON (BLUE) (Max. 300mA) 2 3 4 5 C CONTROL RELAY 6 7 8 Attention The connector wiring may vary depending on the car manufacturer, even when ISO connectors are used. We recommend to check the car's wiring provision before connecting the car stereo. Please pay particular attention to pin 5, where a misconnection might cause damage to the car or radio. Take special care when installing into '98 or later VW/Audi/ Skoda/Seat models as there may be a 12 V connection on Pin 5, which could damage the car stereo or into Ford from '97 or later, with an ISO connector, on which damage to the car's microcomputers is possible if misconnected. Use of ISO connector adapters available on the market may facilitate installation. 7 A From antenna B To the wiring of the vehicle colors of leads. · BLACK: · ORANGE: · PINK: · RED: · YELLOW: · BLUE: This lead is for the ground connection. This lead is for the phone line connection. This lead is for the dimmer line connection. This lead is for connection to the power supply terminal when the ignition switch is set to ACC. This lead is for connection to the battery (back-up) terminal from which power is always supplied. This lead is for the power antenna connection. · BLUE/WHITE: This lead is for the remote amplifier on connection. C Speaker Connections 1 2 3 4 5 6 7 8 REAR FRONT FRONT R R L REAR L Connecting to Auxiliary Equipment (Optional) Connect the AUDIO OUTPUT jack of this unit to the AUDIO INPUT jack of the Auxiliary Equipment. FL (Front Left) FR (Front Right) RL (Rear Left) RR (Rear Right) To AUDIO OUT To AUDIO IN To AUDIO IN Amplifier 8 Basic operation Turning the unit on Press MUTE/PWR (POWER on the remote control) or any other button. Note When you insert the CD in the CD slot, the unit turns on. Turning the unit off Press and hold MUTE/PWR (POWER on the remote control). Selecting a source Press SRC S repeatedly to select a source. To cancel, press XDSS again. 11 Radio operation Listening to radio stations 1 2 3 Press SRC S to select the tuner. Press the BAND repeatedly to select a band. The indicator lights up in the following order. FM1 t FM2 t FM3 t MW(AM) B Auto Seek : Press - [b/B[ + (?m m/M M?When a station is received, searching stops. B Manual Seek : Press and hold - [b/B[ + (?m m/M M?on the remote control) until "MANUAL" appears, and then press it repeatedly. The frequencies move up or down step by step. Storing and recalling broadcast frequencies You can easily store up to 6 broadcast frequencies for later recall at the touch of a button. 1 2 3 Press BAND to select desired band you want to store. Press one of preset buttons 1-6 and hold until the beep sound. The number you have pressed will flash in the preset number indicator and then remain lit. [. . . ] ­ SCAN or SCAN disappear from the display window and the intro scan is cancelled. 2 Repeat The current selected tracks/files (1 RPT) or folder ( 1 2 3 RPT) on the disc is played repeatedly. ­ 1 RPT appears on the display window. CD MP3 WMA Press and hold RPT for about 2 seconds during playback. ­ RPT appears on the display window. [. . . ]