User manual LG LAM770T1

[. . . ] LM770T1/LAM770_ENG_LGEPL_MFL41488902 7 inch Wide TFT color TV System/Mobile Monitor OWNER'S MANUAL LAM770T1/LAM770 Before connecting, operating or adjusting this product, please read this instruction booklet carefully and completely. Table of contents Important Safety Instruction Main features Installation 3-6 7-8 9-14 Parts supplied . . 11-12 Installation order for the stand (Rear seat monitor) . . 15 . 16 . 17 . 17 Operation 18-21 Power ON/OFF . . 20-21 Troubleshooting Specifications 22-23 24 2 Important Safety Instruction CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT SPLIT COVER(OR BACK) NO USER SERVICEABLE PARTS INSIDE. [. . . ] The TV function will be had, but the LAM770 does not have TV mode. LAM770T1, when in TV mode , the menu button is pressed the TV tuning menu will be had the CHANNEL, BADD/ERASE, BSOUND SYSTERM, BFINE TUNE, BAUTO MEMORY and ALL RESET FUNCTIONS can be used, but the LAM770 doesn't have the function. The remote controller is different. the LAM770T1 has 0-9 number buttons, but the LAM770 doesn't have. The LAM770T1 has TV antenna but the LAM770 doesn't have. " 8 Installation Parts supplied AV Cable Cigar light adapter Remote Control Section-mount cradle (Front) Section-mount cradle (Rear) Cover case Before installing At low temperature (20°C. . . or less) Turn on the heater for a proper temperature. (to enhance adhesive power). At high humidity (fog, rain and so on) After making adhesive side dried with a dryer, install the TV. After installing of the Stand Pulling the Monitor stand or installing the Monitor within 24 hours of the stand installation may weaken adhesive power of the stand. 9 Installation Installation order for the Stand 1. Decide a place for installation and make a forming by bending the adhesive side of the Stand according to the shape of the place. Wash the adhesive side cleanly with a neutral detergent or alcohol. After uncovering a double-sided tape out of the Stand, install it. Double-sided tape Notice If the temperature of the adhesive side is low (20°C. . . or less), the adhesive power of the tape may be weaken. To prevent this, stick the Stand after heated. (The screws is not supplied. ) Notice After screwing, check and take notice to escape any damage to the wire or the equipment of dashboard inside. While putting the stand screw into a hole placed on the back side of the monitor unit, adjust installation height and angle. Notice Adjust the height and angle of the unit to reach a dashboard in order to prevent trembling by the vibration of a vehicle. After adjusting the height and angle, surely screw to fix it. While driving, this may be the cause of an accident by its bolting. 10 Installation Treatment of monitor cable Importance · If the Monitor is installed and the Cable connected, put the cable in a good order not to disturb a safe driving. · Pay attention to the cable not being caught in the rail of a door or a seat. The cable may be cut by its getting caught in. · Because it is very dangerous for the cable to be rolled up by a shift lever, arrange it well with a cable clamp. Installation of monitor unit Importance · The Monitor unit of this product is designed taking a serious views for safety. · Unless you surely install it on a safe place, this may be the cause of an accident and be very dangerous. · When you decide a place for attachment, check following notices necessarily. 11 Installation Adhere it on a place not to disturb the operation of air bags. Importance · Do not install on the place where disturbs front sight and the operating of steering, transmission shift lever, brake pedal and makes other passengers risky. [. . . ] AUTO Press the b or B buttons to start auto search. All active channels will be preset and stored into the memory automatically. After presetting, the TV will go to the channel before the auto search starts. 21 Troubleshooting Check following points first before judging as trouble. Although you have checked following points, if a problem still remains, call the service center in this manual and we will take a proper action. [. . . ]