User manual LG LAP240

[. . . ] The openings shall be never be blocked by placing the product on a bed, sofa, rug or other similar surface. This product shall not be placed in a builtin installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer’s instruction has been adhered to. CAUTION concerning the Power Cord Most appliances recommend they be placed upon a dedicated circuit; That is, a single outlet circuit which powers only that appliance and has no additional outlets or branch circuits. Check the specification page of this owner’s manual to be certain. [. . . ] 3. Remove the Wall bracket install guide. 4. Fix it with screws (not supplied) as shown in the illustration below. SCREEN Note , , LAP240-NS. DDEULLK_ENG. indd 11 2013-10-23 9:14:45 12 Getting Started The order of installation wall mount bracket center screw Note , , The order of installation wall mount bracket side screw Note , , 1 Getting Started A B C D A B 1. After inserting the C screw adjust the left and right center. 2. After ensuring the flatness insert B screw. 3. A, D screw fixation after inserting B, C 1. Tightening the B screw. 2. Then, aligning the flatness tighten the A screw. 3. Confirmed the position of the screws after A , B screw loose while checking flatness. screw. 5. Prefixed with bracket left / right guide according to screen side and bottom line. 6. Remove the wall bracket install guide. 7. Fix it with screws as shown in the illustration below. Screen and wall-bracket position 8. Hang the main unit onto the bracket as shown below. LAP240-NS. DDEULLK_ENG. indd 12 2013-10-23 9:14:47 Connecting 13 yy Do not install this unit upside down. It can damage the parts of this unit or be the cause of personal injury. yy After the unit is turned on by AUTO POWER function, it will be automatically turned off if there is no signal for a certain period of time from the external device connected by an optical cable. yy Depending on the connected device, this function may not operate. yy It is not available to turn on the unit by AUTO POWER function if you turn off the unit directly. yy On bluetooth function, this unit may be turned on by AUTO POWER function depending on the connected bluetooth device. But in this case, this unit will be turned off automatically. Using Bluetooth technology About Bluetooth Bluetooth is wireless communication technology for short range connection. The sound may be interrupted when there is interference by the other electronic waves which run on same frequency or if you connect bluetooth devices in the other rooms nearby. Connecting individual devices under Bluetooth® wireless technology does not incur any charges. A mobile phone with Bluetooth® wireless technology can be operated via the Cascade if the connection was made via Bluetooth® wireless technology. Available Devices : Mobile phone, MP3, Laptop, PDA etc. Note , , 3 Operating Bluetooth profiles In order to use Bluetooth® wireless technology, devices must be able to interpret certain profiles. This unit is compatible with following profile. A2DP (Advanced Audio Distribution Profile) LAP240-NS. DDEULLK_ENG. indd 16 2013-10-23 9:14:49 Operating 17 Listening to music stored on the Bluetooth devices Pairing this unit and Bluetooth device Before you start the pairing procedure, make sure the Bluetooth feature is turned on in to your Bluetooth device. [. . . ] Replace the battery with new one. No Power No sound No woofer sound 4 Troubleshooting The Auto power on/ off function does not yy Depending on the connected device, this function may not operate. Check the details below and adjust the unit according to them. yy Switch [ON] state of DRC function to [OFF] by using remote controller. yy With the sound bar connected with TV, change the AUDIO DIGITAL OUT setting When you sense that on TV Setup Menu from [PCM] to [AUTO] or [BITSTREAM]. [. . . ]