User manual LG LB-M7280BS

[. . . ] 5 Accessories Included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Installation Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-7 Air Conditioner Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Operating Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Cut the foam seals(adhesive type) to the proper lengths and attach them to the window frame. Open the window sash and place the window slider kit on the window stool. Attach the window slider kit to the window stool. Adjust the length of the window slider kit according to the height of window. Screw down the two screws on the window slider kit. Cut the adjustable window slider kit if the height of window is less than 26. 6 inches (Fig. Close the sliding sash securely against the window slider kit. Drive two 1/2" screws to secure the window slider kit to the window sash. Drive two 3/4" screws to secure the window slider kit to the window stool. Cut the foam seal to an appropriate length and seal the open gap between the sliding sash and outer window sash, as shown in Fig. 19. To secure the sliding sash in place, attach right angle sash lock with 1/2" (12. 7mm) screw as shown. (Fig. 20) Foam seal (adhesive type) Fig. The air conditioner will control room temperature automatically round the temperature point set by you. The "Sleep" mode program can be cancelled at any time during operation by again pressing the "Sleep" button. Note: This feature is unavailabe under FAN or DRY modes. All rights reserved. AUTO MODE: FAN MODE: TIMER OPERATION: SLEEP OPERATION: 2009 Electrolux Home Products, Inc. 9 Operating Instructions Operating Instructions (continued) SWING OPERATION: When you turn on the unit, the louver will swing and stop at a certain angle. You can press the SWING button to let the louver swing automatically. Press the SWING button again while you want the louver stop at desired angle. This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) which above the "Filter" button will illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Filter" button and the light will go off. CHECK FILTER FEATURE: FAULT CODE: If the display reads "EA" , the room temperature sensor has failed. Contact your Authorized Frigidaire Service Center. If the display reads "ES" , the evaporator temperature sensor has failed. Contact your Authorized Frigidaire Service Center. If the display reads "E4" , the display panel communication has failed. Contact your Authorized Frigidaire Service Center. If the display reads "P1" , bottom tray is full. [. . . ] Rust on the interior or exterior of the unit. Products purchased "as-is" are not covered by this warranty. Food loss due to any refrigerator or freezer failures. Service calls which do not involve malfunction or defects in materials or workmanship, or for appliances not in ordinary household use or used other than in accordance with the provided instructions. [. . . ]