User manual LG LD-12AW2

[. . . ] These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. · A suitable conduit entries, knock-outs or glands shall be provided in the cable entries of this product in the end user. This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] It allows the user to connect the IP device using the URL, rather than an IP address. This also solves the problem of having a dynamic IP address. IP filtering The access of the IP addresses in the list are allowed or denied according to the choice made in the drop-down list of the Basic policy option. The administrator can add up to 10 IP address entries to the list (a single entry can contain multiple IP addresses). The users from these IP addresses need to be specified in the user list with the appropriate access rights. The IP list is to control the access permission of clients by checking the client IP address. DDNS status > Don't use DDNS server: Disable the DDNS function. > Use DDNS server: Enable the DDNS function. Hostname: Enter the hostname you want to use. · Save: Click this button to confirm the settings. 36 Operation and settings IP list > Basic policy: Select the basic policy type. Allow all: Allow all the IP address basically, but the IP addresses in the list are denied. Deny all: Deny all the IP address basically, but the IP addresses in the list are allowed. Maximum RTP stream connection > Maximum number of simultaneous stream connection: Set this number to limit the number of simultaneous stream connections. The connections depend on the stream configuration as shown in the following Maximum RTP stream connection by stream configuration. Note: Remember the password. > Edit the registered user You can change the password or authority. Choose the user ID and then click the [Edit] button. Change the Password or Authority, then click the [Save] button to confirm your selection. Note: The default administrator user ID `admin' is permanent and cannot be deleted. > 39 Operation and settings Video Codec H. 264 H. 264 MJPEG MJPEG MJPEG Resolution D1 D1 D1 Half D1 D1 Frame Rate (NTSC) 30 30 30 30 15 Schedule settings Quality HIGHEST MEDIUM MEDIUM MEDIUM MEDIUM Maximum RTP stream Up to 5 Up to 10 Up to 1 Up to 2 Up to 10 Recording schedule This IP device provides video monitoring, recording and event management functions. Users can record video continuously, on schedule, on alarm and/or on motion detect. Note: Preview window of the IP device setting and preset setting are affected by this setting. · Save: Click this button to confirm the settings. 40 Operation and settings To set the Recording Schedule 1. Recording schedule setting window is displayed. Set the [Pre alarm] and/or [Post alarm] option. Pre alarm: Specifies the maximum recording time before the event detection. [. . . ] If the images appear to have white of gray stripes on it, upgrade the Video graphics driver on the client PC to the latest version. Video images may be noisy if you are using the camera in a very low light environment or the bit rate/ quality is set to very low values. Provide higher values for quality and support the surrounding environment with enough light. Audio condition · The client computer that is interacting with the camera needs to have a sound card that is functional to support speaker and microphone. [. . . ]