User manual LG LD-14AT2

[. . . ] 29 2 Contents Frequently asked questions . 31 General problems with the dishwasher . 48 Cleaning the drain pump and non-return valve . 55 3 IMPORTANT SAFETY INSTRUCTIONS WARNING When using your dishwasher, follow basic precautions, including the following: Electrical Safety ~ Before installation, make sure that Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. [. . . ] If the door is closed, the program will continue from where it was interrupted. , Open the door with care. Before closing the door again, leave it ajar for approx. This will enable the temperature in the wash cabinet to settle. Close the door firmly until it clicks into place. Changing a program If the detergent flap is already open do not change the program. If a program has already started and you wish to change it: ^ Press the "Start/Stop" button for at least one second. The "Start/Stop" indicator lights. ^ Select and start the desired program. Preparing your appliance for an extended vacaion If you elect to turn off the water to your home for an extended period of time, please note that this may not be enough to reduce the risk of a leak. To be completely safe, you must turn off the water supply to each individual appliance. This means under the sink for a dishwasher, at the laundry bib for your washer, etc. 28 Additional options Default settings All settings can be reset to the factory default. ^ Turn the dishwasher off "s". ^ Press the "Start/Stop" button and at the same time turn the dishwasher on "s". ­ Open the water supply all the way. ­ Clean the water intake filter, see "User Maintenance Instructions". ­ The water pressure at the water connection is lower than 4. 35 psi. Consult a plumber. Water drain fault. There may be water in the ­ Clean the drain pump wash cabinet. See "User Maintenance Instructions" for more information on the above. ­ Remove any kinks in the drain hose. 31 Frequently asked questions General problems with the dishwasher Issue The display turns off. Possible fault The dishwasher has gone into "Standby" mode to save energy. Detergent is left in the The dispenser was damp dispenser at the end of when detergent was a program. Detergent residue is The detergent lid blocking the catch. The door and the interior walls are still It is the normal operating wet after a program has mode of the drying finished. [. . . ] If there is any question concerning the proper electrical connection or grounding of this appliance to the power supply, please consult a licensed electrician or call Miele's Technical Service Department: U 1-800-999-1360 V 1-800-565-6435 Specifications The dishwasher comes equipped with a 4 ft (1. 2 m) power cord with a molded plug for connection to 120 V, 60 Hz, 15 A grounded receptacle. 53 Plumbing Waterproof system All Miele dishwashers have a safety valve located on the incoming water line and a sealed underside with a water sensor. If a fault occurs, the water intake is stopped and the drain pump is activated. Providing the dishwasher was installed correctly by a Miele technician, the waterproof system will protect you from water damage throughout the lifetime of the machine. ­ The water inlet hose comes equipped with a 3/4" female hose thread connector. [. . . ]