User manual LG LD-2131SH

[. . . ] 50 Cleaning the drain pump and non-return valve . 57 3 IMPORTANT SAFETY INSTRUCTIONS WARNING ­ When using your dishwasher, follow basic precautions, including the following: Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. Electrical Safety Before installation, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. This data must correspond to prevent injury and machine damage. Consult a qualified electrician if in doubt. [. . . ] If the door is closed, the program will continue from where it was interrupted. Changing a program If the detergent flap is already open, do not change the program. If a program has already started and you wish to change it: ^ Press the "Start/Stop" button for at least one second. ^ Select the desired program and press the "Start" button. , Open the door with care. Before closing the door again, leave it ajar for approx. This will enable the temperature in the wash cabinet to settle. Close the door firmly until it clicks into place. 32 Additional functions Detergent settings To achieve best results set the detergent used to your dishwasher. The detergent button allows you to select the function "2 in 1" and "Gel". The program cycle sequence will be adjusted for the selected detergent. Depending on the program the program running time may increase. "2 in 1" The function "2 in 1" adjusts the program cycle to the use of "2 in 1" detergent products (detergent with rinse aid). The rinse aid dosage and the rinse aid refill indicator will be deactivated. Once the delay start time has elapsed, the selected program starts. The time display shows the remaining time, the "Delay Start" indicator goes out, and the "Start/Stop" indicator comes on. Delay start display Up to 59 minutes: e. g. 30 minutes = 30 Between 1 h and 9 h 30 min: e. g. 15 h = 15^ Starting a program before the delay start has elapsed A program can be started before the delay start time has elapsed. ^ Press the "Start/Stop" button for at least one second. The "Delay Start" indicator goes out and the "Start/Stop" indicator flashes. ^ Press the "Start/Stop" button. The "Start/Stop" indicator lights. Additional functions Default setting All settings can be reset to the factory default. ^ Turn the dishwasher off "s". ^ Press the "Start/Stop" button and at the same time turn the dishwasher on s. [. . . ] This appliance is equipped with a cord having an equipment grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local codes and ordinances. , Improper connection of the equipment grounding conductor can result in electric shock. Do not modify the plug provided with the appliance; if it will not fit the outlet, have a proper outlet installed by a qualified electrician. If there is any question concerning the proper electrical connection or grounding of this appliance to the power supply, please consult a licensed electrician or call Miele's Technical Service Department: U 1-800-999-1360 V 1-800-565-6435 Specifications The dishwasher comes equipped with a 4 ft (1. 2 m) power cord with a molded plug for connection to 120 V, 60 Hz, 15 A grounded receptacle. 55 Plumbing Connection to the water supply , Do not drink water from the dishwasher! ­ The dishwasher can heat its own water to the temperature required by the wash program. [. . . ]