User manual LG LD-C22735ST

[. . . ] 1), then place a lighted match near the burner. - Electrical ignition Push and turn the knob corresponding to the required burner in an anticlockwise direction until it reaches the full on position (large flame fig. 1), then depress and release the ignition button "E". - Automatic electrical ignition Push and turn the knob corresponding to the required burner in an anticlockwise direction until it reaches the full on position (large flame fig. [. . . ] Check that the appliance is in a good condition after having removed the outer packaging and internal wrappings from around the various loose parts. In case of doubt, do not use the appliance and contact qualified personnel. never leave the packaging materials (cardboard , bags , polystyrene foam , nails , etc. ) within children's reach since they could become potential sources of danger. The measurements of the opening made in the top of the modular cabinet and into which the hot plate will be installed are indicated in either fig. Always comply with the measurements given for the hole into which the appliance will be recessed (see fig. The appliance belongs to class 3 and is therefore subject to all the provisions established by the provisions governing such appliances. The installer should note that the appliance that side walls should be no higher than the hot plate itself. Furthermore, the rear wall, the surfaces surrounding and adjacent to the appliance must be able to withstand an overtemperature of 65K. The adhesive used to stick the plastic laminate to the cabinet must be able to withstand a temperature of not less than 150° C otherwise the laminate could come unstuck. The appliance must be installed in compliance with the provisions in force. Furthermore, it must not pass through compartments that could be used for storage purposes. When using a rubber hose pipe, it is essential to comply with the following instructions: - no part of the pipe must be able to touch parts the temperature of which exceeds 65K. - The pipe must not be pulled or twisted, throttled or tughtly bent. - It must not come into contact with sharp edges or corners. - It must be easy to inspect the entire pipe length in order to check its state of wear. - The pipe must be replaced within the date stamped on the pipe itself. - The appliance complies with the provisions of the following EEC Directives: 90/396 + 93/68 regarding gas safety. It is essential to ensure that the room in which the appliance is installed is permanently ventilated in order to allow the appliance itself to operate correctly. The necessary amount of air is that required for regular gas combustion and ventilation of the relative room, the volume of which must not be less than 20 m3. Air must naturally flow through permanent openings in the walls of the room in question. These openings must vent the fumes outdoors and their section must be at least 100 cm2 (see fig. [. . . ] - The power supply cable must be positioned so that no part of it is able to reach an overtemperature of 65K. - Never use reductions, adapters of shunts for connection since these could create false contacts and lead to dangerous overheating. - The outlet must be accessible after the built-in. Always disconnect the appliance from the electricity main before making any adjustments. [. . . ]