User manual LG LD-S5811WW

[. . . ] 3 GB Upper dish basket with shelf Guide rail for the upper dish basket Salt container Cutlery basket Detergent dispenser Door Control panel Filters Lower sprayer arm Lower basket Upper sprayer arm Housing (depends on the model) Turbo fan heat drying system (depends on the model) Technical Specifications Permitted water pressure: 0, 3 ­10 bar (= 3 ­ 100 N/cm² = 0, 01-1, 0Mpa) Electrical connection: 220-240 Volts, 10 Amps (see type plate) Output: 1900-2200 W Heat output: 1800 W This device corresponds to the following EU directives: 2006/95/EC: Low Voltage Directive 89/336/EC: EMV Directive 93/68/EC: CE Marking Directive DIN EN 50242: Electrical dishwasher for home use Testing procedures for practical service conditions Because we continually strive to improve our products, we may change our specifications and designs without prior notice. Note for Testing Institutes The necessary information for performance testing will be provided upon request. The request can be done by e-mail through: dishwasher@standardloading. com Please do not forget to write the model code and stock code information of the appliance besides your contact information in the e-mail. The model code and stock code information can be found on the rating label, which is placed on the side of the door. 2 Safety Instructions Before Installation Check the appliance for transit damage. [. . . ] When the dishes are less dirty, it is generally sufficient to fill the detergent up to the 15 cm³ mark. If your dishes have been in the dishwasher for some time without being washed, you should also fill the small detergent container up to the line (2). Multipurpose detergents give satisfying results only under certain usage conditions. Observe the instructions of the detergent manufacturer on the package when using such detergents. Contact the detergent producer if your dishes are wet and/or if you notice lime spots particularly on your glasses after the washing program is over. When you give up using such detergents: Make sure that salt and rinse aid compartments are full. Set the water hardness to its highest degree and perform an empty run. After the empty washing review the user manual and readjust the water hardness level so as to suit your water supply. Make the appropriate rinse aid settings. Depending on the model, salt indicator and/or rinse aid indicator should be enabled again if they are disabled before. Loading the dishwasher General: Before you load the dishwasher with dishes · Remove coarse food leftovers · Place all containers such as cups, glasses and pots into the machine with the opening facing downwards (so that no water can collect) · Dishes and cutlery may not be placed above each other · Glasses may not touch · The movement of the spray arms must not be hindered · Place all large and very dirty items in the lower basket. · Small and light items can go into the upper basket. To set the height, push the rack upwards and fold it open in position (G). When finished, check that the sprayer arm can still move freely. 1019 17 GB Loading suggestions Load the upper basket with dessert plates, cups, glasses etc. 1027 Upper basket with variable height setting (depends on some models) The upper basket is equipped with a lifting mechanism which enables you to change the height of the basket without having to remove it from the dishwasher, even if it is fully loaded. The height of the upper basket was set to its lowest position at the factory. To lift the upper basket to the "high" (A) position, hold it on one side and carefully pull it upwards. To lift the opposite side of the basket, hold it and pull it upwards in the same manner (A). To lower the upper basket, hold the basket lever on one side and carefully lower the basket without releasing the lever (B). Repeat the procedure with the lever on the opposite side of the basket. Make sure that both levers catch at the same height. 1021 18 GB Height setting with empty basket (depends on the model) In this model, the height setting of the upper basket may be changed using the wheels which are mounted at two different heights. Release the latches on both the right and left tracks of the upper basket by pushing them outwards (C). Place the basket back into the tracks at the desired height (E). [. . . ] Overloading the baskets - In order to avoid scratches and breaks in glasses and other glass tableware because of collision with each other during washing process arising from their placement, do not overload the baskets in excess of their capacity. 1037 Rusts, Blackening And Corruption Of Surface Unsealed closing of the salt box cover* - Salt may cause oxidation on metal surfaces. Use the supplied salt funnel while filling in softening salt. Make sure that the salt box cover is tightly closed after finishing the filling process. Run a washing program to clean up the salts spilled in the machine. [. . . ]