User manual LG LH-C6230

[. . . ] Instead, they are requested to directly contact a designated service center or the outlet at which the product was purchased. Never spill any kind of liquid into the unit. Should this happen, unplug or main switch off the unit and contact an authorized service center. Do not insert anything between the air outlet blades because the inner fan may be damaged and could cause injury. [. . . ] or x Press the on the unit until the indicator lights up x Press the button on the remote control. or x Press the on the unit until the indicator lights up x Press the button on the remote control. or x Press the on the unit until the indicator lights up Med Low Result: Each time you press a button, the unit beeps. 5 E-8 To control the direction of the air flow, refer to page 11. Heating Your Room You must select the Heat mode if you wish to heat your room to a specific temperature. You can also set the fan speed. Remote Control Control Panel 1 If necessary, press the (On/Off) button. x The operating mode indicator (COOL, FAN or HEAT) on Result: the unit comes on. x The air conditioner starts up in the mode selected when the unit was last used. air Theunit conditioner is fitted with a protection mechanism to prevent the from being damaged when it is started immediately after being: x Plugged in x Stopped It will start up automatically after about three minutes. 2 If the HEAT indicator is not lit up on the unit: x Press the button on the remote control or x Press the MODE button on the unit one or more times until the HEAT indicator lights up x The unit beeps each time you press MODE. Result: x The air conditioner starts up in Heat mode. 3 You can change modes at any time. To adjust the temperature, press the or button on the remote control one or more times until the required temperature is displayed. To adjust the temperature, press the or button on the unit one or more times until the required temperature is displayed. Possible temperatures are between 16°C and 30°C inclusive. x Each time you press the temperature buttons: Result: ­ The temperature is adjusted by 1°C and displayed on the control panel ­ The unit beeps x The air conditioner starts heating if the room temperature is lower than the selected temperature. 4 To set the fan speed to. . . x The air conditioner switches off automatically when the operating time reaches zero. You can change the setting mode, fan speed, and air flow direction after setting the Off timer. To Cancel the Off Timer To cancel the Off timer, press: x Timer on the remote control or unit one or more times until " " is displayed. or x on the remote control or unit (The air conditioner operates in the mode selected when the unit was last used. ) E-13 Setting the Sleep timer The Sleep Timer can be used when you are cooling or heating your room to switch the air conditioner off automatically after a period of 8 hours. Remote Control Control Panel 1 2 If you wish to switch the unit off at a specific time, refer to page 13. Make sure that you have selected either COOL or HEAT mode. Press the or Press the Result: button on the remote control button on the unit until the SLEEP indicator lights up. x Each time you press a button, the unit beeps. x The "SLEEP" passes through the control panel for about 15 seconds and the " " will be displayed. x The remaining time is displayed and decreased by 1 hour automatically to indicate the remaining time. x The air conditioner will be controlled as illustrations below. Cooling When the temperature has been increased by 1°C (after 1 hour), it is maintained for 7 hours. Set TEMP. Start time 1hr 8hr Stop time Heating The temperature is decreased by 1°C after 1 hour. When it has been decreased by 2°C (after 2 hour), the temperature is maintained for 6 hours. To Cancel the Sleep Timer To cancel the timer, press: x on the remote control. x The SLEEP indicator is no longer displayed. [. . . ] Check that the correct operating mode has been selected COOL or HEAT. The room temperature may be too low or too high. Dust may be blocking the air filter; refer to page 17 or 18 for cleaning instructions. Check that there is no obstacle blocking the air flow into or out of the unit. [. . . ]