User manual LG LH-C6231W

[. . . ] Periodically examine the cord of your appliance, and if its appearance indicates damage or deterioration, unplug it, discontinue use of the appliance, and have the cord replaced with an exact replacement part by an authorized service center. Protect the power cord from physical or mechanical abuse, such as being twisted, kinked, pinched, closed in a door, or walked upon. Pay particular attention to plugs, wall outlets, and the point where the cord exits the appliance. To disconnect power from the mains, pull out the mains cord plug. [. . . ] Prepare screws and brackets. Wall Mount Brac ket Installation Template 2 Connecting Unit Wall Mount Bracket Installation Template Wall bracket 1. Match the TV's BOTTOM EDGE of Wall Mount Bracket Installation Template with the bottom of TV and attach to the position. TV Screws and Wall Plugs are not supplied for mounting the unit. We recommend the Hilti (HUD-1 6 x 30) for the mounting. Please purchase it. , Note LH-C6231W-N0_DCHNLLK_ENG_4435. indd 10 2012-03-23 4:56:28 Connecting 3. Remove the Wall Mount Bracket Installation Template. Fix it with screws (not supplied) as shown in the illustration below. 11 5. Hang the main unit onto the bracket as shown below. 2 Connecting y Do not hang onto the installed unit and avoid any impact to the unit. y Secure the unit firmly to the wall so that it does not fall off. If the unit falls off, it may result in an injury or damage to the product. y When the unit is installed on a wall, please make sure that a child does not pull any of connecting cables, as it may cause it to fall. > Caution Detach the unit from the bracket as shown below. , Note LH-C6231W-N0_DCHNLLK_ENG_4435. indd 11 2012-03-23 4:56:28 12 Connecting Setting up Pairing wireless subwoofer LED indicator of wireless subwoofer Manually pairing wireless subwoofer When your connection is not completed, you can see the red LED on the woofer and woofer is not made sound. y USB Flash Drive : Devices that support USB1. 1. y The USB function of this unit does not support some USB devices. USB device requirement 2 Connecting Removing the USB Device from the unit. Choose a different function mode or press I (STOP) twice in a row. Remove the USB device from the unit. LH-C6231W-N0_DCHNLLK_ENG_4435. indd 14 y Devices which require additional program installation connected to a computer, are not supported. y Do not extract the USB device while in operation. y For a large capacity USB, it may take longer than a few minutes to be searched. y To prevent data loss, back up all data. If you did not connect external devices with optical cable or there is no digital audio signal going to the unit, the unit will turn off after 15 minutes of inactivity if AUTO POWER function is turned on. y Depending on the connected device by the optical cable, this function may not operate. , Note LH-C6231W-N0_DCHNLLK_ENG_4435. indd 15 2012-03-23 4:56:29 16 Operating Sleep Timer Setting Press one or more times to select delay time between 10 and 180 minutes, after the unit will turn off. To cancel the sleep function, press repeatedly until "SLEEP 10" appears, and then press once again while "SLEEP 10" is displayed. You can check the remaining time before the Unit turns off. [. . . ] When you replace the batteries of the remote, the code number you have set may be reset to the default setting. Set the appropriate code number again. Depending on the unit being connected, you may not be able to control your TV using some of the buttons. , Note LH-C6231W-N0_DCHNLLK_ENG_4435. indd 18 2012-03-23 4:56:30 Troubleshooting 19 Troubleshooting PROBLEM Plug in the power cord. No Power Check the condition by operating other electronic devices. No sound The power cord of woofer is not connected. [. . . ]